Do you have to program a new Ficm?
Do you have to program a new Ficm?
Yes it will come programmed from the parts store for the 03. If it needed to be programmed the directions I gave you would have said you need to program it. The ficm should come programed.
Is there a fix for a Ford 6.0L FICM?
3 After disconnecting the battery, the FICM can be unbolted and unplugged for removal. Bullet Proof Diesel has made a business out of fixing the multitude of known issues with the 6.0, so naturally they have a fix for a weak or dying FICM—in fact, they have several.
How to test the FICM on a Ford F-350?
1 The FICM on this F-350 is mounted over the driver’s side valve cover. Before taking the FICM out of the truck, remove the service cover and do a diagnostic test (as outlined in the truck’s service manual) to see if it’s actually bad. 2 A simple voltmeter is all that’s needed to do the initial testing of the FICM. If it tests bad, remove it.
Do you need to replace the FICM case?
7 This is the inside of a stock FICM. When upgrading just the power supply, the upper half of the case and the control board are retained. Replacing the entire unit is always an option, but more often than not it’s the power supply, rather than the control board, that’s the source of the problem.
Can a FICM power supply be replaced at a lower cost?
The lower-cost solution comes in the form of a replacement FICM power supply, which plugs into the original control board. One advantage to this method is that it preserves any FICM flash updates that may have been installed by the dealer when the truck was in for service. If the FICM is replaced, it should be flashed with the latest updates.
When is FICM replacement for Ford Super Duty?
This is a completely refurbished and pre-programmed replacement fuel injection control module (FICM) for your 2003-2009 6.0L Ford Super Duty with a 5 year warranty . Each FICM is programmed (flashed) for your specific vehicle. All orders placed by 3:00PM EST will ship the SAME BUSINESS DAY !!!
1 The FICM on this F-350 is mounted over the driver’s side valve cover. Before taking the FICM out of the truck, remove the service cover and do a diagnostic test (as outlined in the truck’s service manual) to see if it’s actually bad. 2 A simple voltmeter is all that’s needed to do the initial testing of the FICM. If it tests bad, remove it.
How to change FICM in Ford 6.0L diesel?
6 With the screws under the window cover removed, flip the FICIM over, remove the eight screws that hold the case together, and carefully pry the two halves apart. 7 This is the inside of a stock FICM. When upgrading just the power supply, the upper half of the case and the control board are retained.
When to replace the FICM relay on a Ford truck?
We recommend replacing the FICM relay if your truck has over 100,000 miles. This is often overlooked but can cause a no start condition. It is located in the fuse box on the drivers side fender well in the engine bay.
