How do You reset the anti theft system on a ford freestyle?

Insert the key into the ignition, and turn it to the on position. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off. Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again. Repeat the process for a third time.

How to reset anti-theft on 2006 ford freestyle?

Sit in the driver’s seat with the doors closed. Turn the key in the ignition to ON, so the interior lights and radio work, but the engine isn’t activated. The anti-theft light will either be solid or blinking. Leave the key in the ignition in this position for around 10 minutes.

What makes a Ford no crank no start?

You’ll see that the system consists of a fuse, ignition switch, starter relay, transmission range selector (neutral safety switch on for an automatic transmission) or a start inhibit switch for a manual transmission, and a ground control circuit provided by the PCM. The PCM gets involved here because of the ford passive anti-theft system (PATS).

How to reset the anti theft system in a Ford?

1 Insert the key into the ignition and turn it on to the position where the accessories are activated but not the engine. 2 Leave the key in this position for at least 10 minutes. 3 Check the anti-theft light again. 4 Now try to start the engine. 5 Repeat the process at least a couple of times if it does not work the first time.

Where is the anti theft light on a Ford?

The display of the car behind the steering will light up and will show the anti-theft light blinking or constantly lit. Leave the key in this position for at least 10 minutes. Check the anti-theft light again.

What to do if your car anti theft light is not blinking?

Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car. Step 4: Start the engine. Attempt to start your engine.

What to do if your car anti theft system is not working?

Step 1: Check your key fob battery. A car’s anti-theft system may activate if your key fob battery is dead and hasn’t disabled the system. Make sure the battery is installed correctly in your key fob. If the battery is correctly installed, replace it with a fresh battery and try again.

How do You reset the anti theft system ON a ford freestyle?

How to reset security system ON 2006 ford freestyle?

How to change the Pats on a Ford?

Simply put the original key in the ignition, turn to ON or RUN and wait for 20 seconds. Then turn the key off and start vehicle. Replacing PCM only — B, C, F or G type PATS If only the PCM is being replaced on a PATS control function type B, C, F or G vehicle, the Parameter Reset function must be performed.

How to relearn Ford Pats control function module?

Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.

How to relearn Ford Passive Anti-Theft System ( PATS )?

Replacing PCM only — A or D type PATS If only the PCM is being replaced on a PATS control function type A or D vehicle, no relearn is required (please refer to the Ford PATS chart to determine PATS type). Simply put the original key in the ignition, turn to ON or RUN and wait for 20 seconds. Then turn the key off and start vehicle.

Can you use aftermarket keys with Ford Pats?

The Ford FCSD aftermarket remote entry system comes with a starter interrupt that should be disabled on PATS equipped vehicles. Do not use aftermarket keys that are NOT Ford qualiﬁed.

When to look for fault codes in Ford Pats?

Look for fault codes in The PATS function will store fault codes when the PCM records a P1260. Be certain of the vehicle model Use only parts & keys speciﬁed for the appropriate model year. Check to make sure the issue is not with multiple PATS keys, small electronic devices that can be used to purchase gasoline, or other items on same key ring.

How to solve Ford Passive Anti Theft System PATS trouble?

There is no communications with PCM ; PCM will always communicate on the diagnostic link regardless of theft status. (Investigate PCM system) Engine stalls on road: Once the engine runs for one second, PATS CANNOT disable the engine. Running stalls are not PATS issues.

How do You reset the anti theft system on a ford freestyle?