How to get a data link scanner to activate?
How to get a data link scanner to activate?
Data Link scanner must target whatever it wants to scan and be within a tiny range – sub 400m in ship, usually in SRV if can target its close enough already and can scan it from there. Comp Scanner does not need to target the object its scanning, just be looking/pointing at it and usually glows a bit to show its found something.
Is the datalink scanner active on buttton 1?
Data point is active. I’ve tried putting data link scanner on buttton 1, button 2, switching between combat and explore mode etc etc. Data point is active as it has raised up (and says active!) Composition? There is no separate fire group option for turret unless I’m missing something??? Edit.. Thought you were in a ship. Not working either.
Can a data link scanner be left in combat?
Just for the record, both data & comp scanners in SRV work in both Combat & Analysis so no need to switch modes, can be left in Combat. Data Link scanner must target whatever it wants to scan and be within a tiny range – sub 400m in ship, usually in SRV if can target its close enough already and can scan it from there.
Why is the OBD II scanner not communicating?
Check the fuse box (Power Panel), it might be the reason why PCM isn’t able to receive power as well as communicate.
Why is my OBD II scanner not connecting?
My OBD II scanner won’t link with my 2006 Civic EX. It plugs in fine, but when you hit the “LINK” button to retrieve codes, after about 10 seconds, the scanner comes up “ERR” Had a gas cap message that turned into a check engine light. Changed the cap and needed to clear the code.
Why does my Honda Civic scanner not link?
It plugs in fine, but when you hit the “LINK” button to retrieve codes, after about 10 seconds, the scanner comes up “ERR” Had a gas cap message that turned into a check engine light. Changed the cap and needed to clear the code. Removed the battery overnight and the code cleared but, the scanner still won’t retrieve codes.
Why does my car scanner say ” linking error “?
The car has no major mods.. I could figure out why It wouldnt read> I was about to give up and I tried telling the scanner my car was a 96 and it worked. It kept saying communications error unable to communicate with vehicle check power and grounds etc.
When do I get ” linking error ” OBDII Comm failure?
Dec 24, 2008 I have been having so much trouble with this car so I finally went out and bought a nice OBD II Scanner. Relief came when the scanner arrived but it did not last long. I booted it up correct and as it tried to connected I get “Linking Error”.
Why is my OBD II scanner not communicating?
OBD II Scanner refuses to communicate with the vehicle! Could I have a faulty ignition switch? Or an open somewhere? How do I go about troubleshooting this? It cycles through all the protocols, finds none and fails to communicate.
Data Link scanner must target whatever it wants to scan and be within a tiny range – sub 400m in ship, usually in SRV if can target its close enough already and can scan it from there. Comp Scanner does not need to target the object its scanning, just be looking/pointing at it and usually glows a bit to show its found something.
Just for the record, both data & comp scanners in SRV work in both Combat & Analysis so no need to switch modes, can be left in Combat. Data Link scanner must target whatever it wants to scan and be within a tiny range – sub 400m in ship, usually in SRV if can target its close enough already and can scan it from there.
Data point is active. I’ve tried putting data link scanner on buttton 1, button 2, switching between combat and explore mode etc etc. Data point is active as it has raised up (and says active!) Composition? There is no separate fire group option for turret unless I’m missing something??? Edit.. Thought you were in a ship. Not working either.
Check the fuse box (Power Panel), it might be the reason why PCM isn’t able to receive power as well as communicate.
