What to do when your Ford Focus wiper stops working?
What to do when your Ford Focus wiper stops working?
Driving in rain on country two lane highway at 35 to 45 mph, turned on slow windshield whippers and only driver side came on for a few swipes then the passenger side whiper came on for two passes. For the next 10-minutes while driving in the rain, only the driver side whiper worked.
Is there a recall on the 2012 Ford Focus?
Any damaged or inoperative wiper motors will be replaced. All of these inspections and repairs will be carried out free of charge, of course. If you have questions in the meantime, we encourage you to contact Ford at 866-436-7332 and ask about recall #12S29. Alternately, you can ring NHTSA at 888-327-4236 and inquire about campaign #12V149000.
Are there any problems with the Ford Focus?
Other Common Visibility related problems of Ford Focus Problem Category Number of Problems Wiper problems 142 Power Window problems 44 Windshield problems 24 Side/rear Glass problems 16
Why are my windshield wipers not turning off?
When there is a failure on the LIN8 network, the wipers will operate for 5 min on high, 5 min on low, 5 min on intermittent,then shut off. This might be what’s happening with your car. This means there is most likely a wiring problem between the BCM and driver’s wiper motor. Click to expand…
Is there a problem with the windshield wiper on a Ford Focus?
According to a bulletin from the National Highway Traffic Safety Administration, the flaw in the Focus has been traced to the harness connector that holds the electrical wires powering the passenger’s side windshield wiper. A seal in that connector may be missing, and over time, water, debris, and other gunk could accumulate inside.
Any damaged or inoperative wiper motors will be replaced. All of these inspections and repairs will be carried out free of charge, of course. If you have questions in the meantime, we encourage you to contact Ford at 866-436-7332 and ask about recall #12S29. Alternately, you can ring NHTSA at 888-327-4236 and inquire about campaign #12V149000.
Why do my windshield wipers stop in the middle?
What a bunch of horrible answers. The reason for the wiper blades stopping in the middle is that the stop switch, inside the motor assembly, is not parking the wipers in the required position. It is the new motor that is faulty. Was this answer helpful? simply remove the blades and replace at the start position at the bottom of the screen.
What happens when you turn the wiper switch backwards?
periodically, when engaging the wipers by turning the switch backwards, it will operate normally, or almost, with one to two swipes before shutting down. Some times, however, it will continue for many swipes and may stop in random positions.
