What to do if your reverse band is broken?

Without being over detailed, more than likely the reverse band has broken or the reverse servo is damaged. I say this since you heard a “bang”. It would be wise to take the vehicle to reputable transmission shop for diagnosis. By lowering the transmission pan for an inspection by a trained specialist one can determine if the servo is broken.

What is the 5 speed gear on a 5R55N?

5R55N / 5R55W / 5R55SRWD 5 Speed A Input Shaft Overdrive Ring Gear Overdrive Center Shaft Center Support Intermediate Band Direct Drum Forward Clutch Forward Planet Reverse Band Reverse Drum Low Sprag Stator w/Gears B C D E

How to fix a bad 4R55E transmission in a truck?

Now its time to button up! Go ahead and put the new separator plate on and install the 3 bolts. Torque these to 71 INCH POUNDS and then retorque them to 97 inch pounds. Now crawl under the truck and look up inside the transmission. There was a huge

Is there a problem with the Ford 5R55E?

The 5R55E featured more accurate computer controls (to accommodate the additional forward gear) and introduced adaptive shift control. In this case I would agree that you have a transmission problem.

What should the band be on a 5R55?

Painted one corner of the 4 point adjusting bolt and adjusted them to 120in/lbs, backed them off two full turns. A while ago I read somewhere there was an updated TSB saying to only go 1.5 turns but I couldn’t seem to find anything on it now, so I went the full two – I can always turn them in another half a turn if needed.

Is there a fix for Ford mountaineer 5R55W transmission?

The following instructions and fixes were developed after plenty of research, design, and reasoning into the following issues with the Ford/Mercury Mountaineer 5R55W transmission. NOTE: One thing that is recommended is to do a band adjustment on your vehicle to make sure you do not have a broken or excessively-worn band.

What to do if your reverse band is broken?