What does it mean if your Pats key is not recognized?
What does it mean if your Pats key is not recognized?
If the test returns B1600 code (B10D7:87 for new PATS), it means the blank key is not recognized by PATS and can NOT be programmed for this vehicle. 3.3. If the test returns B1602 code (sometimes simulatenously with B1600, B1601) (B10D7:8F for new PATS), it means PATS is unable to stably read the key transponder.
Can a Ford Pats key read a PID?
If the key is not programmed into the vehicle you will get an security error of course but it will still be able to read the keys code, if it can’t read the keys code there is a separate PID that is set. The point is you find out if your vehicle can read the key before trying to program it in. Thanks, sir!
Where is the theft indicator on the Pats key?
The PATS key has a visual theft indicator which is located on top of the instrument panel. When you turn the ignition switch on, the indicator will prove out for about three seconds. If there is a problem with the PATS key, the flash tends to glow steadily or glow for more than five seconds. How it works
How to check blank Pats key using forscan?
This article describes how to check a blank key using FORScan. 0. Insert the blank key in the ignition lock. 1. Detect the module that contains PATS. It is easy: go to Service tab and look what module contains PATS programming function. Depending on the vehicle, it may be PCM, PATS, IC, HEC etc.
Are there any PATs related ECU’s that are defective?
ECU is defective (EEPROM in PCM is not working – replace PCM). PATS related when stored in PCM only. B1600 B10D7-87 Non-PATS Key or damaged key. B1601 B10D7-51 Unprogrammed encoded ignition key detected (leave ignition on for 20 seconds before trying a programmed key, in Anti-Scan Mode) B1602 B10D7-8F Particial detection of encoded ignition key.
Why is my Pats key not working on my car?
Devices that power up the PCM without powering up the PATS Control module can experience no-start concerns. Items such as foil stickers, brass key tags, other PATS keys, and other transponders used to purchase gasoline or other metallic objects can cause interference with the PATS key.
What should I do when replacing my Pats key?
When replacing the Powertrain Control Module (PCM) on a PATS-equipped vehicle, a parameter reset or relearn procedure must be performed after the PCM is installed. B1213:Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103:Transceiver internal antenna damaged. Replace transceiver.
What can cause interference with the Pats key?
Items such as foil stickers, brass key tags, other PATS keys, and other transponders used to purchase gasoline or other metallic objects can cause interference with the PATS key. Make sure you have all of the customer’s keys when doing reprogramming, PATS Control module replacing, or diagnosis.
