How to replace a rear hub bearing on a Ford Explorer?

Learn more… This information is from the Ford Service Manual for a 2002 Ford Explorer, however it can be used for all 2002-2005 Ford Explorer, Mercury Mountaineer and Mercury Mariner vehicles. Remove the wheel and tire assembly. Have an assistant press the brake pedal to keep the axle from turning. Remove the nut and washer and discard the nut.

What happens when you take the hub off a Ford Explorer?

Hold the caliper out of the way but do not allow it to hang by the brake hose. Hanging the caliper from the brake hose can cause internal damage to the brake hose. The brake caliper will slide off of the hub once the caliper is removed. Do not damage the boot while separating the toe link from the knuckle.

How do you remove a wheel hub assembly?

Then start disassembling the brakes by removing the caliper bolts and the bracket bolts. Next, remove the rotor. If the vehicle has anti-lock brakes, disconnect any wiring harness plugs. Loosen all the bolts that hold the wheel hub assembly onto the knuckle. Once that is done, you should be able to remove the wheel hub assembly as a unit.

What happens if you loosen the hub retainer?

Do not loosen the axle wheel hub retainer until the wheel and tire are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied. Thanks! wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors.

Can a 2002 Ford Explorer be used as a Mercury Mariner?

This information is from the Ford Service Manual for a 2002 Ford Explorer, however it can be used for all 2002-2005 Ford Explorer, Mercury Mountaineer and Mercury Mariner vehicles. Remove the wheel and tire assembly. Have an assistant press the brake pedal to keep the axle from turning. Remove the nut and washer and discard the nut.

How to replace the rear hub bearing on a Ford Explorer?

Loosen the lug nuts from the wheel which the bearing is going to be replaced. Step 2: Raise and secure the vehicle. Raise the vehicle and secure it on jack stands, and then remove the wheel. Place blocks of wood underneath the front and rear of the wheel diagonally opposed from the one you will be working on.

How to replace a wheel hub assembly step by step?

How to Replace a Wheel Hub Assembly Step 1: Prepare your work area. Make sure the vehicle is on a level, safe surface, and you have set the parking brake. Step 2: Loosen the lug nuts. Use a ½ inch drive breaker bar and a lug nut socket set to loosen all the lug nuts and axle… Step 3: Jack the

What happens when a rear hub bearing fails?

They hold the entire weight of the vehicle and are subject to the harsh conditions of the road, as well as exertion from the torque of the engine. When they fail, they will begin to make a howling noise, which will progress into a grinding, and when completely failed may seize, rendering the vehicle undriveable.

What was the hub assembly on a 2002 Ford Explorer?

Contains: Snap Ring, bearing, Knuckle, Dust Shield, Mountain Bolts and axle Nut. 17mm Tie Rod Stud Diameter. Built from 03/04/2002 Notes: Axle Repair Bearing. Solid axle. Replaces bearing and Seal. Notes: Hub assembly, Left. Complete Knuckle Assembly.

How do you repair a broken wheel hub?

The axle basically floats inside the hub and you can usually push slightly on the end of the axle to make sure it is disengaged from the hub. Remove the nut and bolt and the wheel knuckle, hub and bearing as an assembly. Take the entire assembly and a new hub repair kit to a machine shop and let them do the actual press work.

How to replace a rear hub bearing on a Ford Explorer?