What happens when you power close the liftgate?

Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).

How to disable the power liftgate on a GM car?

1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.

When does the liftgate stop on an equinox?

The power liftgate may stop when opening from the fully closed position (usually opening not more than 15 inches, or 38 cm) or will not close from the open position on some 2018-2019 Equinox and Terrain models.

Why does my 2015 Kia liftgate not open?

My trunk on my 2015 with 5,600km , it just all of a sudden the trunk button on the liftgate to close it does not work at all. The remote button to open trunk works fine to open and close it but if I push button on license plate to open it just unhinged and have to open manually and the button won’t close it.

What to do if your power liftgate reverses?

3 Sill plate activating liftgate close switch. Inspect the sill plate for proper installation/clearance to the touch pad switch and possible bent retainers. Power liftgate reverses while closing at the start (top) of travel. 1 Strut stanchion (strut dries out while sitting open for long periods).

How to check if your liftgate is working?

2 Key fob sending a double hit signal (Some key fobs will send a second hit signal upon release of the button when held longer than 1 second, others will send a second signal if you roll your thumb while holding down the button or a combination of the two together). Inspect the key fob operation. 3 Touch pad sending a second signal.

What to do if power liftgate does not close?

14) Straighten any misaligned terminals and reconnect the connectors. Verify proper opening and closing of the power liftgate. If DTC B153F is set, check that the male terminals in the liftgate object sensor connector to the liftgate harness are stable. Any misaligned terminals may cause intermittent electrical contact.

What is the DTC for the power liftgate?

DTCs B153E (Liftgate Position Sensor Signal Circuit), B153F (Liftgate Object Sensor Signal Circuit) or B396A (Left Liftgate Motor Control Circuit) may be set in the power liftgate module.

How does a Kia power liftgate work?

Hyundai, Kia, and Genesis models with hands-free power liftgates open three seconds after detecting the key fob in close proximity to the trunk. Lexus vehicles have a sensor on the rear badge and require the owner to place their hand in front of it to open.

Where is the sensor on a power liftgate?

Remove the liftgate upper center and upper side trim panels to access the B71L Liftgate Object Sensor – Left or B71R Liftgate Object Sensor – Right connectors. (Fig. 15) Check for any bent or misaligned terminals in the liftgate object sensor male in-line connector.

How do I get the lift gate to close on my head?

I get a slight bump and then it goes back up. Open the lift gate from the inside switch, take the key fob out of your pocket and leave it in the car. You will find when your back there, the lift gate will no longer close on your head. Bottom line, don’t be dancing around close to the bumper with the key fob in your pocket.

How do you open power rear lift gate?

The only way to open the gate was to pop the small access cover off the interior of the gate and use the manual release. Flash forward to the solution. I wasn’t able to come up with anything (online or otherwise) so I resorted to the dealer. Luckily, the Toyota gods had mercy on me, and the solution was an easy one.

What happens when you power close the liftgate?