Where is the blower motor on a Chevy Colorado?

The blower motor is located within the vehicle under the passenger side lower I/P. This location, while allowing for increased serviceability, does not offer much isolation from blower motor noise. To reduce the noise level from the blower motor, install a blower motor sound insulator cover using the procedure below. 1.

How do you remove a HVAC fan from a Chevy Colorado?

1. Remove the right hinge pillar trim panel. 2. Remove the blower motor mounting screws. 3. Remove the blower motor cooling tube (2). 4. Disconnect the blower motor electrical connector (4). 5. Remove the blower motor (3). Be sure to have a 1/4″ univeral joint to flex into a tight location near the firewall for the third screw on the fan motor.

Where is the blower ground on a GMC Canyon?

Pull the plastic off of that area in front of the door under the glove box. My harness, along with others have had the wires for the blower melted. Cut it out of both sides, attach a new piece of wire as a jumper, and re connect the harness.

Where are the ground connections on a blower motor?

The fan resistor and speed switching is done on the negative side of the motor and is most likely where your problem is. The two major failure points on the negative side are the resistor connections and the ground connections at the fender.

Is there a problem with the Chevy Colorado?

This feature is not available right now. Please try again later. This is a fix for a known electrical issue with the 2003-2012 Chevrolet Colorado and GMC Canyon. There is a harness that shorts out, and burns up the resistor which in turn burns up the rest of the harness. This is a step by step guide Loading…

How can I reduce the noise from the blower motor?

To reduce the noise level from the blower motor, install a blower motor sound insulator cover using the procedure below. 1. Remove the front passenger door sill molding. 2. Remove the front passenger side interior kick panel molding. 3. Remove the front passenger interior floor courtesy light. 4. Remove the BCM connector facing the blower motor.

How do you remove a blower motor from a Chevy Colorado?

1. Remove the front passenger door sill molding. 2. Remove the front passenger side interior kick panel molding. 3. Remove the front passenger interior floor courtesy light. 4. Remove the BCM connector facing the blower motor. 5. Remove the wire retaining metal clip from the BCM harness. 6. Install the molded insulator to the blower motor.

Do you need to replace the HVAC blower motor?

The blower was working fine and stopped on all 4 speeds. The fuse and relay are fine. Just checked them both. I need the instructions to remove and re-install the HVAC blower motor. Did you check with a meter at the connector on the blower motor to see if you have 12 volts there?

Is the blower for my AC and heater working?

This morning I went to work and the A/C was working… a few hours later I started the Colorado 04″ with the ac on and fan on setting 4 and now the blower wont work on any speeds… any suggestions? not a day goes by…….

Where is the ground wire on a Chevy blower?

If the yellow light stayed on then you have a ground problem. If it went out then you probably have a bad blower motor. The ground wire is located in a little black box called a Splice Pack. It’s official designation is called SP106.

Where is the blower motor on a Chevy Colorado?