How do I get my ford Ranger out of theft mode?
How do I get my ford Ranger out of theft mode?
Resetting Your Anti-Theft System
- Put the key in the ignition.
- Turn it to the on position, but don’t start the engine.
- Turn it back off again.
- Repeat this process eight times, leaving your key on with the final turn.
Why are the brakes on my Ford Ranger not working?
Checked reservoir, low. Added more dot3 and pumped brakes POP brake line near gas tank broke due to corrosion (rust). Fixed the line, bled brakes and replaced pads. Still smoking if I drive it. weird thing is; they dont grab right when I start driving, it takes a little bit of braking before they slow me down.
Is there a problem with the Ford Ranger 4 wheel drive?
For others however, the problem isn’t as obvious. In fact, we’ve seen people sell 4-wheel drive Ranger’s cheap because the 4-wheel drive wasn’t working when the only problem was with the automatic locking hubs. With automatic hubs, there is no need to stop or get out of the vehicle to lock them in.
Why is my front hub not working on my Ford Ranger?
There are (3) reasons why the front hub may not engage the axle shaft and work: 1) There is to much grease or other crap in the hub to allow the splined collar to fully engage the splines on the axle shaft. 2) The washer (spacer) is missing behind the snap ring on the axle shaft allowing it to travel and disengage from the hub.
Can a 2001 Ranger be converted to a knuckle?
Your 2001 and newer has what is called a “live axle” which simply means that the cv’s are physical attached to the hubs via a nut and spin at a constant speed with the wheels. On this truck the disconnect is the transfercase. However, what you can do is convert your truck to a ’98-’00 1/2 style Ranger knuckle.
Are there any problems with the 1998 Ford Ranger?
See all problems of the 1998 Ford Ranger . When putting vehicle in 4 wheel drive at any speed there is a humming sound. When taking it out of 4 wheel drive vehicle will jerk. Dealer replaced transfer case on 1 June 2001. After putting the vehicle into four wheel drive, the vehicle suddenly stopped.
For others however, the problem isn’t as obvious. In fact, we’ve seen people sell 4-wheel drive Ranger’s cheap because the 4-wheel drive wasn’t working when the only problem was with the automatic locking hubs. With automatic hubs, there is no need to stop or get out of the vehicle to lock them in.
What’s the problem with the clutch on a Ford Ranger?
Issue: You have to push the clutch to the floor to shift gears. Problem: More times than not, you still have air in the clutch line and need to further bleed the system. Fix: If a new installation: check pedal height and adjust to factory specifications.
Checked reservoir, low. Added more dot3 and pumped brakes POP brake line near gas tank broke due to corrosion (rust). Fixed the line, bled brakes and replaced pads. Still smoking if I drive it. weird thing is; they dont grab right when I start driving, it takes a little bit of braking before they slow me down.
