Do you have a problem with your brakes?
Do you have a problem with your brakes?
Brakes really spongy…pedal hits the floor!! I think I have a problem with the brakes in my NC (has ABS) …when you push the pedal a few times on the spot while the car is runing, the pedal is all spongy and it goes so far back that it hits the floor same happens when driving if you use it alot in a short period of time….
What does it mean when your car brakes are spongy?
The booster applies a vacuum assist to the pedal – a faulty booster will normally manifest itself as non-responsive brakes – not a spongy pedal . If your brakes are spongy usually you have air in the system somewhere.
Why are my brakes spongy and pedal hits the floor?
But don’t mistake fliud loss for the normal fall of fluid in the reservoir that comes with the wearing of the brakes. Thats exactly why there is a reservior. A common sign of ACTUAL fluid loss is the loss of paint on the booster (brake fluid is an excellent paint remover – wash off with water if you spill it somewhere.
What happens when you bleed the brakes at the master cylinder?
When bleeding the brakes at the caliper work from the furthest brake from the master cylinder back. Also remember you should CHANGE the fluid regularly – I do mine 2 yearly – because brake fluid absorbs water – which in the situation of hot brakes can cause the water to turn to steam & vapour-lock the brakes on.
Why are the brakes slow to release on my Ford Expedition?
Click to expand… Thanks, I’ll give that a try this weekend and see if that will help or not. Take off the calipers, remove and clean the slides, the areas where the pads touch and slide on (silver clips) and now here’s the part no-one checks and does REMOVE THE RUBBER SLIDE BOOTS AND CLEAN THE RUST BUILDUP INSIDE THE CALIPERS!
What does it mean when your brake pads don’t release?
Pedal is returning as expected. It does feel like the pads are not releasing all the way after being held for more than a minute or so. It’s not making any squeaking noises regularly, just when I start to depress the brake you’ll hear a squeak for a second then goes away as I keep the pedal depressed.
How to diagnose hard brake pedal master power brakes?
A) With the engine not running, press and depress the brake pedal several times to remove any vacuum from inside the booster. B) On the last push of the brake pedal, hold moderate pressure on the brake pedal. Don’t push like you are panic stopping, but simply hold pressure like you are sitting at a red light.
Why are the brakes so slow to release?
I recently (within last month) changed all the brakes and rotors. Pedal is returning as expected. It does feel like the pads are not releasing all the way after being held for more than a minute or so.
