Is the 2010 V6 Mustang fast?
Is the 2010 V6 Mustang fast?
Although 210 hp isn’t much, neither is the V-6 Mustang’s 3421-pound curb weight. Acceleration is decent, at 6.6 seconds to 60 mph and the quarter-mile in 15.3 at 93 mph, but in a recent comparison test of the V-6 Hyundai Genesis and Chevrolet Camaro, both beat the Mustang through the quarter by about a second.
How fast does a 2010 Ford Mustang V6?
What is 2010 Mustang GT top speed?
| Top speed: | |
|---|---|
| (theor. without speed governor) | 251 km/h / 156 mph |
How much HP can a 2010 Mustang GT handle?
GT Gone said: The stock motor can handle up to 450 RWHP. You wont get up to 650-675 HP without a forged block, a stronger tranny, and an upgraded fuel system.
How much horsepower does a 2010 5.0 Mustang have?
315 hp @ 6000 rpm
Used 2010 Ford Mustang GT Premium Coupe Specs & Features
| Engine | |
|---|---|
| Cam type | Single overhead cam (sohc) |
| Cylinders | V8 |
| Horsepower | 315 hp @ 6000 rpm |
| Torque | 325 lb-ft @ 4250 rpm |
Is it bad to Rev to high RPMs?
Yes, high RPMs are bad for the engine. But once the engine is warmed up, it’s not that bad for it. Use the engine in its main power band when you are accelerating hard. That’s where the engine was designed to be used.
Why does my car not Rev at 3000 rpm?
I was sitting in the garage with the car running thinking over my exhaust problem and decided to rev the engine up near the redline to see how it handled it. As it reaches about 2800-3000 RPM it starts to stumble and fluctuate and wont rev any higher.
Is it possible to take the engine off at 3, 000 rpm?
You can take it off with a programer. But its there for a reason and its a good thing.:hy: Mine WILL rev over 3,000 RPM’s – it just starts coughing at 85 mph and shuts down at about 90 mph. I found that out the first time I got mad at an old woman doing 25 mph on the highway and passed her. 6,000 RPM’s when it downshifted, in nothing flat!
What’s the RPM on a four-wheel drive car?
As it reaches about 2800-3000 RPM it starts to stumble and fluctuate and wont rev any higher. A few times I could get it up to 3500 RPM before it dropped back down to 2800-3000 RPM and started crapping out again.
