Are there any brake problems in my Ford Focus?

Ford Focus owners have reported 16 problems related to brake master cylinder (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Focus based on all problems reported for the Focus.

Are there any recalls on 2012 Ford Focus?

We have a 2012 Ford Focus sfe, the high economy model. This car exhibits the same symptoms described in the �soft brake pedal recall� issued recently. The brake pedal can be applied directly to the floor, not reliably stopping the car. Sometime it can be pumped up, sometimes not.

Is the 2011 Ford Focus a good car?

(14) (0) The 2011 Ford Focus goes down as one of the most reliable and affordable vehicle I have owned, and I have owned a few. I bought it used in 2013 with 30,000 and the only maintenance I have had is a full set of brakes and 10 oil changes in the last 15,000.

What causes the brake caliper on a Ford Focus to stick?

Your Ford Focus’s braking system is the most important safety feature on the vehicle. If it does not work properly, it can put you in a situation where you can be injured or killed. There are quite a few different situations that can cause a caliper to stick.

Why is my master cylinder not working on my Ford Focus?

The brake pedal can be applied directly to the floor, not reliably stopping the car. Sometime it can be pumped up, sometimes not. In October the master cylinder was replaced at a cost of $445. 36 to no avail. Then the abs-anti skid controller box was replaced, again to no avail.

Why is my brake warning light not working?

These sensors are meant to detect any problem with the vehicle’s brake fluid pressure, which is generated by the master cylinder. If they detect that the pressure has dropped, it is possibly due to a problem with the master cylinder. Such issues may also ignite a Brake Warning Light too.

Why is my Ford Focus not slowing down?

While reversing at 4 mph, the contact depressed the brake pedal and the pedal traveled to the floorboard, failing to slow the vehicle. The vehicle was taken to fraser Ford sales ltd (815 king st w, oshawa, on l1j 8n5, canada), but the dealer was unable to diagnose the cause of the failure.

What are the signs of a bad brake booster?

Common signs of a faulty vacuum brake booster check valve include the brake pedal being difficult to engage, feeling spongy, or not working at all. 1. Brake pedal is difficult to engage

What to do when your car brakes stop working?

In order to remove the air from the brake lines, the brake system will have to be bled. As such, when you experience a problem like this in your vehicle, stop driving it as soon as possible and have the entire brake system professionally examined. 3. Brakes stop working

Why does my car have a brake sensor?

Where can I get a Ford Focus brake line flushed?

The vehicle was taken to fraser Ford sales ltd (815 king st w, oshawa, on l1j 8n5, canada), but the dealer was unable to diagnose the cause of the failure. The dealer flushed the brake lines; however, the failure recurred.

Is there a problem with the Ford Focus?

My Girlfriend hasa got a focus and it has developed a problem with the boot/tailgate. whilst driving along the boot will pop open. Last night it was doing it whenever the brake pedal was pressed and released.

What happens when you close the boot on a Ford Focus?

And when you pull the boot lid closed the momentum of that action over comes the influence “momentarily” of the aforementioned spring. The boot lid is then returned to the closed position. On locking the car remotely or by the key, the electrical feed to the manual release micro switch is cut.

Is there a 2005 Focus with a Mark 2 boot?

If its a 2005 Focus then it will be a mark 2. As for the boot problem, one of the flaws with the mark 2 Focus boot was that water could get in to the boot switch causing it to fail. Maybe the boot switch on your girlfriends car is faulty causing it activate at certain times?

What to do if your Ford Focus has a tailgate problem?

Easy way to check this is to “short” out the two wires that connect to the switch. If the solenoid does it job, you know the fault lies in the micro switch. If it is water ingress that is bugging up the micro switch. You need to replace the switch, and try and ensure water does not get into the switch housing again.

Are there any problems with the 2002 Ford Focus?

CarComplaints.com Notes: The 2002 Ford Focus 2.0L SOHC engine has a defect where the intake valve seat fails. The valve then falls into the cylinder, destroying the engine & most owner relationships with Ford in the process.

Are there any brake problems in my Ford Focus?