How do you remove tailgate on Ford Raptor?
How do you remove tailgate on Ford Raptor?
About 12” from the end of the rod on both sides. You need to remove the tailgate, loosen the two small bolts that clamp the rod in place on the passenger side and then slide the rod out of the tailgate. Reposition the grommets about 12 inches from either end of the torsion rod.
How does a torsion bar work on a tailgate?
The torsion bar helps you lift the tailgate to close and supports the weight on the way down. The hydraulic assist struts only slow the drop, they do not help with lifting the tailgate to close. The torsion bar does both. 724687
How do you remove a torsion spring from a platform?
Apply pressure to the passenger side torsion spring arm in the counter-clockwise direction. Use an open-end wrench, crescent wrench, or vice grip (Figure 1). 3. Remove the 1/2″ bolt and nut from the platform. Continue to hold counter-clockwise torque on the torsion spring arm. 4.
Is it easy to lift a tailgate on a truck?
You will be able to lift your tailgate with ease because the torsion bar makes your 30- or 40-lb tailgate feel like it weighs just 4 to 7 lbs. Relevance Newest Rating – High to Low Rating – Low to High Install this torsion bar between your truck bed and tailgate to make it easy for you to raise and lower the tailgate on your truck.
About 12” from the end of the rod on both sides. You need to remove the tailgate, loosen the two small bolts that clamp the rod in place on the passenger side and then slide the rod out of the tailgate. Reposition the grommets about 12 inches from either end of the torsion rod.
How does a torsion rod work on a tailgate?
There is a torsion rod running through the tailgate. On this torsion rod there are two rubber grommets that prevent the bar from touching the bottom of the tailgate. If they are in the wrong position you will hear the rod smacking the bottom of the tailgate right before it shuts.
How do you remove a torsion rod from a car?
You need to remove the tailgate, loosen the two small bolts that clamp the rod in place on the passenger side and then slide the rod out of the tailgate. Reposition the grommets about 12 inches from either end of the torsion rod. Reassemble and you’re popping sound will disappear. It’s a pain in the butt but that is the true fix.
What do I need to install tailgate assist?
All mounting hardware is included and no drilling is required for installation. Truck Tailgate Assist is designed specifically for each make and model, which makes installation a breeze. Safely Controls The Drop Rate of Your Tailgate
