Where is the 2013 Ford Escape blend door actuator located?
Where is the 2013 Ford Escape blend door actuator located?
The blend door actuator in a 2013 Ford Escape is located on the passenger side of the dash behind the glove compartment, and behind a plastic access panel. It will be on the side of the actual blend door assembly which is part of the duct work in the vehicle.
Where is the a / C heater blend door actuator located?
1. Remove the instrument panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim. 2. Disconnect the LH temperature blend door actuator electrical connector. 3. Remove the 2 LH temperature blend door actuator screws. 4. Remove the LH temperature blend door actuator.
How long does it take to replace blend air door actuator?
Calibration of the actuators will take approximately 30 seconds. Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct DEFROST/PANEL/FLOOR operation. As far as no heat from the left side, that is a blend air door actuator. Here are the directions for the left side actuator replacement.
How to find the actuator on a blender?
You to start removing lower dash covers and then use a flashlight to locate the actuator. Some spot are a little tight use 1/4 drive tools to remove the actuators. Let us know what happens and please upload pictures or videos of the problem. helpful?
The blend door actuator in a 2013 Ford Escape is located on the passenger side of the dash behind the glove compartment, and behind a plastic access panel. It will be on the side of the actual blend door assembly which is part of the duct work in the vehicle.
1. Remove the instrument panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim. 2. Disconnect the LH temperature blend door actuator electrical connector. 3. Remove the 2 LH temperature blend door actuator screws. 4. Remove the LH temperature blend door actuator.
Calibration of the actuators will take approximately 30 seconds. Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct DEFROST/PANEL/FLOOR operation. As far as no heat from the left side, that is a blend air door actuator. Here are the directions for the left side actuator replacement.
You to start removing lower dash covers and then use a flashlight to locate the actuator. Some spot are a little tight use 1/4 drive tools to remove the actuators. Let us know what happens and please upload pictures or videos of the problem. helpful?
