Why is my 2012 Ford Fusion AC not working?
Why is my 2012 Ford Fusion AC not working?
The most common causes that hinders normal operation of air conditioning system on your Ford Fusion are dirty cabin air filter, refrigerant leak, dirty or clogged condenser, dirty or clogged evaporator, bad blower motor, defective compressor, faulty blend door actuator or any fault in the electrical system.
Where is the temperature sensor on a 2012 Ford Fusion?
The 2012 Ford Fusion has a coolant temperature sensor that can be found by accessing the bottom of Your vehicle, or through the hood. First, go to the front of the engine, and open the hood, using the prop arm on the passenger side of the engine bay to secure it in an open position.
Are there any problems with my 2012 Ford Fusion?
2012 Ford Fusion AC / heater problems with 29 complaints from Fusion owners. The worst complaints are a/c blowing hot, a/c sensor not working, and ac/heater shut off randomly.
Why is my Ford Fusion air conditioner not working?
Related Ford Fusion Problems Find the most common driver-reported problems that are to blame when a Ford Fusion has air conditioning problems. You may not realize there’s a refrigerant leak until the air conditioner stops blowing cold. When the compressor fails, the most common symptom is warm air from the vents.
Why is the a / C blowing hot in my Ford Fusion?
If car is setting in the sun or a hot place, A/C will blow hot. open the hood and touch A/C lines and they are cold. A/C is working as it should, but the blend door is in the heater position, even though the control knob is set to A/C. I believe the HVAC module does not operate properly when it is hot.
Where is the cold air sensor on a 2012 Ford Fusion?
The part is only about $25 but the issue is that the sensor is located behind the dash. Because of the placement of the sensor and how the 2012 Fusion is made the center console as well as the dash has to come out. If you take it to a shop they are going to charge an arm and a leg.
Related Ford Fusion Problems Find the most common driver-reported problems that are to blame when a Ford Fusion has air conditioning problems. You may not realize there’s a refrigerant leak until the air conditioner stops blowing cold. When the compressor fails, the most common symptom is warm air from the vents.
If car is setting in the sun or a hot place, A/C will blow hot. open the hood and touch A/C lines and they are cold. A/C is working as it should, but the blend door is in the heater position, even though the control knob is set to A/C. I believe the HVAC module does not operate properly when it is hot.
Are there any problems with the Ford Fusion?
Take a look at NHTSA’s data on the subject. And much like the power steering, we’re still seeing the same throttle body failures that started in 2010 continue in 2012. No one has added a helpful site for this 2012 Fusion problem yet. Be the first!
Where is the AC EVAP sensor on a 2012 Ford Fusion?
What it seems to be for most people is the AC Evap Temp Sensor that is faulty. The part is only about $25 but the issue is that the sensor is located behind the dash. Because of the placement of the sensor and how the 2012 Fusion is made the center console as well as the dash has to come out.
