What is the drive cycle on a Ford?

Newer Ford owner’s manuals include a drive cycle, which is as follows: The OBD-II system is designed to check the emission control system during normal driving. A complete check may take several days.

How to clear a Ford driving cycle OBD-II?

1. Install scan tool. Turn key on with the engine off. Cycle key off, then on. Select appropriate Vehicle & Engine qualifier. Clear all DTC’s/ Perform a PCM Reset. Bypasses engine soak timer.

When do you turn off the drive cycle?

Note that this step must occur within 4-10 minutes from a cold engine startup (if the drive cycle does not begin within 10 minutes of a cold engine startup, turn the key off to reset the timer and then restart the engine). Then decelerate back to 0 mph without touching the brake pedal or the clutch pedal on models with manual transmission.

When does the PCM suspend the drive cycle?

If your battery is more than four years old, replace it and re-run the Drive Cycle. Even though your car may start just fine, the PCM is hypersensitive to the slightest glitch in the battery. It will suspend the Drive Cycle if it is not happy with any aspect of battery performance and/or charging system performance.

1. Install scan tool. Turn key on with the engine off. Cycle key off, then on. Select appropriate Vehicle & Engine qualifier. Clear all DTC’s/ Perform a PCM Reset. Bypasses engine soak timer.

What to do when the drive cycle won’t start?

But if the oxygen sensor and catalyst monitor are ready, then the heater has to be working or the other two monitors would fail and set codes. If the EVAP monitor is not ready, verify that your fuel cap is tight and the level of fuel is between 1/4 and 3/4 full. If all the other monitors are ready, then do a couple more “cold” starts.

How to pass inspection and complete a drive cycle?

If you have a Code Scout 700 http://amzn.to/Nnwvot you can get a reading that tells you how many monitors are ready and how many are incomplete. All 8 monitors need to be in a “ready” status before you can pass inspection.

What should the cruise speed be on a Ford cycle?

For A/T, from a stop and in overdrive, moderately accelerate to 80 Km/h (50 MPH) and cruise for at least 15 seconds. Stop vehicle and repeat without overdrive to 64 Km/h (40 MPH) cruising for at least 30 seconds.

How long does it take to complete a drive cycle?

Always refer to your vehicle service manual or a professional mechanic who has access to the exact drive cycle instructions — and follow them to ensure accuracy. In most cases, a correct drive cycle will take no longer than 15 minutes to complete. Step 1: Finish Repairs and Clear all Fault Codes

What is the drive cycle on a Ford?