What does B1342 code mean?
What does B1342 code mean?
END OF SPECIAL NOTES. OBD II fault code B1342 is most commonly defined as “ECU (Electronic Control Unit) has failed”, or sometimes as “GEM (Generic Control Module) has failed”.
What does ECU internal fault mean?
When a car’s Engine Control Unit (ECU) senses a problem or malfunctioning within the vehicle, it triggers an ECU fault code that will turn on the check engine light. ECU fault codes, also known as diagnostic trouble codes (DTC) are part of the on-board diagnostic (OBD II) system in your car.
What does b1342 mean on an ABS module?
Using my Autel ML629 Scan Tool and checking the ABS module I get a B1342 Fault code saying possible issue with RAM/ROM in ECM.. I assume since I’m scanning the ABS module it means the fault is really with the ABS module not the Engine Control Module? I did look up through Autel to make sure this tool did ABS diag’ on Ford before having a go at it.
What does b1342 mean on a Ford ECU?
Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions. After proper recollection of that code, I remembered, it was a body code B1342. Which equals a antilock brake module failure.
What is the b1342 code on a 2009 Ford Escape?
2009 Ford Escape XLT, V6 with automatic. ABS light is on, 2009 Ford Escape XLT, V6 with automatic. ABS light is on, and traction control light is on. Scanned codes to find, B1342 (1/1)CM, ECU … read more
What does the OBD 2 fault code b1342 mean?
Using my Autel ML629 Scan Tool and checking the ABS module I get a B1342 Fault code saying possible issue with RAM/ROM in ECM.. I assume since I’m scanning the ABS module it means the fault is really with the ABS module not the Engine Control Module? I did look up through Autel to make sure this tool did ABS diag’ on Ford before having a go at it.
Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions. After proper recollection of that code, I remembered, it was a body code B1342. Which equals a antilock brake module failure.
What does b1342 faulty control module code mean?
The B1342 is a fairly straight forward code pointing to a fault with the Electronic Brake Control Module (aka “ABS Module”). When this code sets alone, more times than not, the module has failed internally and will need to be replaced. Inspect the electrical connector and wire harness for any loose, broken or damaged wires before replacement.
What does b1342 stand for on a car?
The B1342 is a fairly straight forward code pointing to a fault with the Electronic Brake Control Module (aka “ABS Module”).
