Can you bypass the factory AMP in a car?
Can you bypass the factory AMP in a car?
Bypassing the factory amp takes a little more work because you have to run the bypass harness to the factory amp, which is often located in some other part of the car. It’s usually worth the extra effort because you’ll get better sound from your new stereo, even if you’re keeping those factory speakers.
Can a car stereo be installed with a factory AMP?
This factory amp is designed to make cheap factory speakers sound better. But it doesn’t do you any favors when you replace the stereo or those stock speakers. Retaining the factory amp usually makes it easier to install a new stereo, and in some vehicles that’s your only option. But your new stereo’s sound is limited to what that amp can do.
Where is the factory AMP on a Toyota?
But if you don’t mind splicing some wires, you can use a speaker-wire bundle, like the Crutchfield CSW9W-20 9-wire speaker cable, to reach the output section of your factory amp. There it is! The Toyota’s factory JBL amp is mounted under the rear seats.
Can a factory AMP work on a JVC speaker?
The factory amp can also include a filter or crossover network for specific frequencies that may not sound optimal with a new system. By bypassing the factory amplifier and feeding the JVC receiver’s power directly to the speakers, Dave also bypassed any filters in the factory amp, sending a pure, full-range signal to the speakers.
Bypassing the factory amp takes a little more work because you have to run the bypass harness to the factory amp, which is often located in some other part of the car. It’s usually worth the extra effort because you’ll get better sound from your new stereo, even if you’re keeping those factory speakers.
This factory amp is designed to make cheap factory speakers sound better. But it doesn’t do you any favors when you replace the stereo or those stock speakers. Retaining the factory amp usually makes it easier to install a new stereo, and in some vehicles that’s your only option. But your new stereo’s sound is limited to what that amp can do.
But if you don’t mind splicing some wires, you can use a speaker-wire bundle, like the Crutchfield CSW9W-20 9-wire speaker cable, to reach the output section of your factory amp. There it is! The Toyota’s factory JBL amp is mounted under the rear seats.
The factory amp can also include a filter or crossover network for specific frequencies that may not sound optimal with a new system. By bypassing the factory amplifier and feeding the JVC receiver’s power directly to the speakers, Dave also bypassed any filters in the factory amp, sending a pure, full-range signal to the speakers.
