How do you adjust the headlights on a Ford Escape?

Locate the vertical adjuster on the headlamp, then use a 4 mm socket to turn the adjuster either counterclockwise (to adjust up) or clockwise (to adjust down) aligning the upper edge of the light pattern to the horizontal line.

How do you turn on the brights on a Ford Escape?

To turn on the high beams on Your car You will need to use the control stick to the left of the wheel. If they are not working You may need new bulbs. Headlights are a very easy thing to replace should they go out, and they are quite cheap. Each bulb will cost You between 10 and 20 dollars on average.

How to turn off the headlamps in a Ford Escape?

Move the opaque cloth to cover the right-hand headlamp and repeat Steps 4 and 5 for the left-hand headlamp. 7. Close the hood and turn off the lamps.

Do you need horizontal aim on Ford Escape?

HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS NON-ADJUSTABLE. Use to adjust the brightness of the instrument panel and all applicable switches in the vehicle during headlamp and parking lamp operation. • Move the control to the full upright position, p …

How to set delay time on Ford Escape?

If your vehicle is equipped with autolamps, you can set the delay time to keep the headlights on for up to three minutes after the key is turned off. The delay time is set to 20 seconds at the factory, but the delay time may be changed by following the steps below (Steps 1 through 6 must be done within 10 seconds): 1. Turn the vehicle off. 2.

What should I do about my 2013 Ford Escape?

2013 Ford Escape SEL 2.0L 4 Cyl. Turbo Replace brake lights Burnt out brake lights increase your chance of getting rear ended – check and change yours today 2013 Ford Escape SEL 2.0L 4 Cyl. Turbo

How do you adjust the headlamps on a Ford Escape?

If this edge is not at the horizontal reference line, the beam will need to be adjusted. 5. Locate the vertical adjuster on the headlamp, then use a 4 mm socket to turn the adjuster either counterclockwise (to adjust up) or clockwise (to adjust down) aligning the upper edge of the light pattern to the horizontal line.

How do you adjust the height of a headlight?

Mark the height of the headlight axis on the wall: Measure up the wall and make a mark on the tape at the height of the headlight axis. Find the headlight cutoff lines: On the driver’s side of the wall, measure four inches below the axis height you marked and draw another line.

Where are the cutoff lines on a headlight?

Find the headlight cutoff lines: On the driver’s side of the wall, measure four inches below the axis height you marked and draw another line. On the passenger’s side, draw a line two inches below the axis height. These marks will serve as cutoff points when you adjust your lights.

How do you adjust the headlights on a Ford Escape?