Why is my blower motor not coming on?
Why is my blower motor not coming on?
With the back wire hooked up I ran a jumper directly to the battery pos and attached it the purple wire terminal on the motor. The motor did not come on. So either my motor is dead shorted or something has gummed up the brushes or they are worn out.
What to do if your AC blower is not working?
Disconnect cables to motor and resistor. Remove hose from motor, it should just pull off with little effort. Unscrew motor and resistor. Screw new motor and resistor in. Connect hose to motor. Connect cables to motor and resistor. Turn on car and test AC. Thanks for watching! Loading…
What happens when a blower motor relay wears out?
Without it, the AC system will not be able to circulate any heated or cooled air. The blower motor relay controls the current used to power the blower motor, and is subject to the constant on and off switching. Over time, it can eventually wear out.
How to replace a blower resistor and motor?
Easy video on how to replace blower resistor and motor with 1 screw driver and in about 10min. Remove glove box, pop bottom panel off to gain motor access. Disconnect cables to motor and resistor. Remove hose from motor, it should just pull off with little effort. Unscrew motor and resistor. Screw new motor and resistor in. Connect hose to motor.
Why does my blower motor not turn on?
Then after dropping stuff at home, got back in the truck & blower motor does not do anything. Checked the #4 fuse, even swapped it with another & still nothing. Im guessing its mot the switch or resistor. So is the motor gone?? Its stupid cold outside so did not check power at the motor, so don’t know it has power or not.
What causes a bad or failing blower motor relay?
Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…
What to do if your Mercedes heater blower is not working?
My blower motor was fixed in with 3 posidrive screws. Had to use a stubby screwdriver on one of them too due to a serious lack of room. Check first before just pulling it out Rooty.
Where is the blower control switch on the dashboard?
The blower control switch on the dashboard controls the circuit flow of the blower motor to adjust the voltage from low, to medium, to medium-high, to high. When on high, the circuit bypasses the blower resistor.
Where can I get a new blower motor resistor?
I replaced the blower motor resistor and the control unit with new parts from rockauto (ACDelco). I’ve checked the fuse in the dash fuse panel and it is good.
How many volts does a blower motor have?
At low is might have 5V, M1 7 ish, and M2 9 ish volts. (note mine is not working and I think resistors are bad I get 11.9V on hi 11.73 v on all other speeds lo, m1, and m2. Anyone ever measure what voltages are normal to speeds ?
Where is the relay on a blower motor?
Correction assuming 97 is same (probably is)… Fan relay is as posted before on top of the duct work left of the resistors you can see both behind the glove box if you take it out. The purple wire comes from the relay/resistors according to fan speed selected.
When to replace the resistor on a heater?
If your fan speed control does not seem to work you may want to replace this fan speed control component. While the switch could have been the issue I also had a squealing blower motor and oftentimes you’ll burn up a resistor when running a squealing heater fan motor.
Why is my heater fan fuse not working?
Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later. CAR HORN NOT WORKING.
Why does my AC blower motor not work?
The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently.
Why is the resistor not working on my blower?
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.
What to do if your blower is not working?
The very first step you need to take is getting a scan run on the computer. Take your car to a technician or a local parts store and have them scan the car. They will give you a list of… Hello there, thank you for asking about your 1998 Oldsmobile LSS.
