How do you reset the dash light on a Ford Fusion?

Turn the ignition to run (one position before starting engine). Press and release SETUP to display “OIL LIFE XXX% HOLD RESET = NEW”. Press and hold RESET for 2 seconds and release to reset the oil life to 100%. Turn the ignition off and then start the engine to verify the indicator has been reset.

How does 3 pin relay work?

RELAY ENERGIZED (ON) Current flowing through the control circuit coil (pins 1 and 3) creates a small magnetic field which causes the switch to close, pins 2 and 4. The switch, which is part of the load circuit, is used to control an electrical circuit that may connect to it.

Where are the fuses located on a Ford Fusion?

If a fuse blows again contact a qualified service center. The fuse panel is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses. The power distribution box is located in the engine compartment.

What to look for when replacing a fuse on a Ford Explorer?

Before you replace or repair any electrical parts, check the appropriate fuses or circuit breakers. To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse.

How do you know if you need to replace a fuse?

To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.

What’s the front screen wiper on a Ford Fusion?

Front screen wiper (Hi.) WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

Where are the fuse panels on a Ford Fusion?

Here you will find fuse box diagrams of Ford Fusion 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Where is the power distribution box located in a Ford Fusion?

The power distribution box is located in the engine compartment. 1. Release the two latches, located on both sides of the fusebox. 2. Raise the inboard side of the fusebox from the cradle. 3. Move the fusebox toward the center of the engine compartment. 4. Pivot the outboard side of the fusebox to access the bottom side.

When did the second generation Ford Fusion come out?

In this article, we consider the second-generation Ford Fusion (US) before facelift, produced from 2013 to 2016. Here you will find fuse box diagrams of Ford Fusion 2013, 2014, 2015 and 2016, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

How do you reset the dash light on a Ford Fusion?