How do you test for high tension leads?
How do you test for high tension leads?
To check the secondary winding, take off the distributor cap and detach the central HT lead (See Inspecting the ignition system ). Remove or push back the cap from the end of the HT lead to expose the core connection. Remove a lead from one of the sparkplugs, then switch on the ignition.
Why do spark plug wires shake?
When a spark plug stops firing, the internal pressure of the motor drops (resulting in power loss), and the remaining cylinders are left to compensate (causes vibration and possible violent shaking). This is a common symptom of a plug or wire electrical current problem.
What are the idle / hunting problems in a 2002 Mondeo?
2002 Mondeo duratec idle/hunting problems help needed. i’m having problems with the idle tick over.when i start the car the hunting starts then after 1 – 2 mins it settles down.I’ve changed the Ht leads to new ones because i thought it was missing.I’ve also put injector cleaning fluid with the petrol.
Why is the fuel flap on my Mondeo not opening?
The solution is to fit a clip to the clutch spring stop to prevent spring elongation. Problem: Fuel flap does not open. Solution: The probable cause is insufficient spring pressure from a lack of material on the flap. A revised filler flap should be fitted. The revised flap has an extra 1mm of material to ensure spring contact.
What’s the problem with the Ford Mondeo power steering?
Solution: When converting a petrol engine into a LPG fuel system, an approved Ford cyclinder head should be used that has special nitration hardened valves and valve seats. This will prevent premature wear and lack of power, poor idling etc. Problem: Knocking noise from the power steering system.
What’s the problem with the left hand drive Ford Mondeo?
On left hand drive vehicles a common problem is the speaker loom vibrating on the heater box which can lead to fretting of the multiplug. The solution here is to fit a new multiplug and re-route the wiring loom. On left hand rive vehicles, the speaker wiring loom has been re-routed since 12/1999.
