How do you remove a brake drum from a car?
How do you remove a brake drum from a car?
Loosen the wheel lug bolts/nuts and raise the rear of the car and place it securely on jack stands. Remove the wheel lug bolts/nuts and remove the rear wheels. Back off the brake adjusting stars, then remove the brake drum from the splines in the rear wheel shaft.
How long does it take to replace a brake drum?
Brake drum maintenance and replacement requires that you first remove the old brake drums from the wheels. This procedure is usually fairly simple, requiring no more than a half hour or so and common vehicle maintenance tools. Park the vehicle in a clear, flat area.
How is a brake drum puller attached to a wheel?
Place each of the brake drum puller’s 3 hooks evenly around the brake drum’s flange. Ensure that the screw in the middle of the brake drum puller lies above the middle of the wheel hub. Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum.
What happens when you change the drum on a car?
Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.
How do you take rear brake drum off?
Unscrew the brake drum if needed. Use a screwdriver to remove the screws securing the brake drum to the wheel. Draw the brake drum forcefully towards you. Use a screwdriver and rubber mallet or a brake drum puller to take the drum off of the wheel if you are unable to remove the drum by unscrewing it and pulling it.
When to change your brake drums?
A brake drum with heat cracks, gouges severe hot spots, or that exceeds the specification limit should be discarded and replaced with a new drum. If you are within spec, these drums can be machined or “turned” at a machine shop.
When to replace brake drums?
Most car mechanics and makers say you should replace your car’s drum brake lining when it has worn down to about 1/8 inches or less. You can tell when this happens by measuring the lining with a tape measure. You should plan on having to replace them about every 12,000 miles, or a year of use, whichever comes first.
How do you remove a stuck brake drum?
Use a puller to remove the drum. Center of the hub should have a depressed area where the puller’s center bolt can be places. Then clip the jaws on the outer edge of the drum and tighten the center bolt until the drum breaks free.
