Is the Ford Fiesta Duratec idle when cold?
Is the Ford Fiesta Duratec idle when cold?
Ford Fiesta: 05 fiesta duratec wont idle when cold. Found a… FORD SENIOR /SPECIALI… Vocational, Technical or Tra… Hi, I have a fiesta st on a 55 plate, I’m having idle issues.
Why is my Ford Fiesta 1.25 Zetec stalling?
Same hunting problem with my 1.25 Zetec so this is what has been done and how the problem started – it may relate to some one elses problem so here it is. Changed plugs, leads, and coil. Had to revert to the local Ford garage for a diagnostic check. Seems that one of the connecting hoses ( don’t know which yet ) had rotted and was letting air in.
What’s the Diagnostic fault code for a Ford Fiesta?
Vehicles that trigger diagnostic fault codes (DTCs) / fault codes P2138 with P2122, P2123 or P2127 a common problem is the PCM (powertrain control module = ECM = engine control module) electrical connector. Check the electrical connector for the PCM for damage to the terminals and pins. Replace or repair as necessary.
Why does my Ford Fiesta not start in the morning?
In the morning when it’s been cold during the night it turns over but will not start straight away. Eventually it does start after turning over … read more Ford Focus 1800 Hatchback Petrol When stopping the engine races up to 3000rpm and slowly returns to tick over. Sometimes on tick over the engine cuts out .
Ford Fiesta: 05 fiesta duratec wont idle when cold. Found a… FORD SENIOR /SPECIALI… Vocational, Technical or Tra… Hi, I have a fiesta st on a 55 plate, I’m having idle issues.
Vehicles that trigger diagnostic fault codes (DTCs) / fault codes P2138 with P2122, P2123 or P2127 a common problem is the PCM (powertrain control module = ECM = engine control module) electrical connector. Check the electrical connector for the PCM for damage to the terminals and pins. Replace or repair as necessary.
In the morning when it’s been cold during the night it turns over but will not start straight away. Eventually it does start after turning over … read more Ford Focus 1800 Hatchback Petrol When stopping the engine races up to 3000rpm and slowly returns to tick over. Sometimes on tick over the engine cuts out .
What’s the problem with my Ford Fiesta 2001?
Ford Fiesta and Fusion 2001 – 2002 Problem: Knock from rear suspension on rough road surfaces. Solution: The most likely problem is the shock absorber top mounts. Revised and updated new shock absorber top mounts should be fitted.
Why is the FITV valve on my Honda engine sticking?
If you continue to obtain different readings with the throttle released, suspect a sticking throttle shaft or faulty TPS. As another example, Honda engines (I believe 1996 and later) feature a FITV (Fast Idle Thermo Valve) that’s located directly under the throttle body. This valve is prone to sticking.
What is the problem with the idle air control valve?
The problem may involve an annoying change (up/down) of engine speed while cruising at a steady pace, a low drop (or even cut-out) at idle or when approaching a stop, a wild high engine speed of several thousand rpm followed by a drop to near zero, etc. • Dirty/sticking IAC (idle air control valve) (P0505)
How to diagnose a faulty idle control valve?
A quick look at a faulty idle control valve on my Ford Escort 1.8 Ghia. The symptons will be very similar across every Car, especially Ford. http://www.youtube.com/watch?v=CS3ZBv… Obviously do not even attempt this replacement if you are not a competant mechanic. Loading…
What can be the problem with the Ford Fiesta MK6?
Ford Fiesta MK6 – Intermittent problem – driving along car will suddenly lose power, will not rev past 4000 – after about two minutes engine picks up again. Idle is then low, about 500, for twenty minutes or so, then all back to normal. What can be the problem?
Why does my Ford Fiesta stall at low revs?
Sounds like the engine is drawing in air somewhere, too much air = stall. I have this exact same problem, all the symptoms are the same. Hunting idle, sometimes, but rarely stalls because of the low idle hunting. Randomly the acceloration cuts out at between 4000 and 5000 revs.
What causes a bad idle on a Ford Zetec?
It is a 5cm rubber T-piece that connects the engine block to the EGR valve and the Pulse air system. Due to the movement of these pieces it often splits and lets out vacuum, resulting in a bad idle and or stalling. Many Agents know about this item and it is one of Ford’s best selling spares for the Zetec.
Why is my idle control not working on my car?
If the idle has not changed at all, it’s likely because your idle control motor has not been functioning. If the idle control motor was working, disconnecting it should have created a difference in the engine’s idle. This test confirms there’s an issue with the idle control motor, but not what the issue may be.
What’s the RPM of a Ford Fiesta ST?
My fiesta ST 2005 is idles at 2500 to 3000 rpm, but only when cold, when the temperature reaches normal, it returns back to ideal at about 1000 rpm. What may be the problem? … read more