Where are the wheel bearings on a Ford Escort?
Where are the wheel bearings on a Ford Escort?
Rear axle & wheel bearings – fordopedia.org Fordopedia table of contents» varia » bearings » rear axle & wheel bearings Rear axle & wheel bearings Ford Escort (1968-1980) “Köln” axle Location Ford part no. Bearing no. Outside dia. Inside dia. Width Bevel pinion – front (B) 71BG 4615 A1AFINIS 0800836 331139 D 64.311 28.587 21.460
Where does the differential Pin go on a Ford axle?
A production axle shaft end never touches the differential pin, in contrast to to the semi-fl oat style used on Ford 8.8-inch axles. For this reason, this very rough cut end was common from Ford during high-volume production. Aftermarket shafts are never this roughly cut.
What should the wheel bearing end play be?
The goal of this recommended procedure is to achieve a verifiable wheel bearing end play of 0.001” to 0.005” (.025 mm to .127 mm). This procedure applies to steer, drive and trailer axle assemblies using conventional double nut or single nut systems on Class 6, 7 and 8 trucks. This refers only to torque specifications and bearing adjustment.
Where is retainer plate on Ford axle shaft?
Partially remove the axle shaft. Notice how the ball bearing traps the retainer plate on the axle shaft. The retainer ring is to the left of the ball bearing. This ring keeps the axle bearing on the axle shaft. Also notice the polished section to the left of the ring from the seal riding on the journal.
A production axle shaft end never touches the differential pin, in contrast to to the semi-fl oat style used on Ford 8.8-inch axles. For this reason, this very rough cut end was common from Ford during high-volume production. Aftermarket shafts are never this roughly cut.
How to install a rear axle pinion bearing?
STEP 1: Place differential pinion bearing (new, or used if in good condition) over aligning disc and insert into rear axle pinion bearing cup of carrier. Place differential pinion bearing into bearing cap and assemble tool handle into screw and tighten to 2.2 Nm (20 lb-in). Item Part Number Description
What to use to adjust tapered roller bearing?
Step 1:Lubricate the tapered roller bearing with clean axle lubricant of the same type used in the axle sump or hub assembly. NOTE: Never use an impact wrench when tightening or loosening lug nuts or bolts during the procedure.
How to remove an axle shaft from a Mustang?
Axle Shaft Removal (1994-2012 Mustang typical) STEP 1: Remove the 10 differential housing cover bolts and drain the lubricant from the axle housing. STEP 2: Remove the differential housing cover. STEP 3: Mark driveshaft position and remove driveshaft STEP 4: Remove the rear brakes
