What causes a Ford Focus ABS pump to fail?
What causes a Ford Focus ABS pump to fail?
Ford Focus & C-Max ABS Pump Module fault Fault code: “C1288 Pressure Transducer Main/Primary Circuit Failure” This ABS Pump Module is a very common failure for the Ford Focus & C-Max vehicles built between 2004 – 2011. The fault causes the ESP light to illuminate permanently on the instrument cluster.
Can a focus and C max abs pump be rebuilt?
Once all the faults have been identified with the ABS our technicians will rebuild the unit using higher rated components than OEM. After receiving the ABS pump and module back from us, there will be no need for programming.
Are there any problems with the Ford C Max?
Check to see if all of the potential problems with your Ford C-Max have been resolved in the past. How to do it, we give advice on a special page. The clutch pressure plate may break while the vehicle is in motion. This may lead to a malfunction of the transmission … . The seatbelts may be defective.
Where do I Send my Ford Focus ABS pump?
Package the Ford Focus & C-Max ABS pump and module inside a sturdy box with plenty of packaging material (make sure you include your confirmation email in the box). Send us your package by tracked courier (the shipping instructions are on the confirmation email).
Ford Focus & C-Max ABS Pump Module fault Fault code: “C1288 Pressure Transducer Main/Primary Circuit Failure” This ABS Pump Module is a very common failure for the Ford Focus & C-Max vehicles built between 2004 – 2011. The fault causes the ESP light to illuminate permanently on the instrument cluster.
Once all the faults have been identified with the ABS our technicians will rebuild the unit using higher rated components than OEM. After receiving the ABS pump and module back from us, there will be no need for programming.
Why does my Ford C-Max engine not start?
Ford C-Max: Engine Cranks → Won’t Start There are a lot of issues that can cause your C-Max to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
Package the Ford Focus & C-Max ABS pump and module inside a sturdy box with plenty of packaging material (make sure you include your confirmation email in the box). Send us your package by tracked courier (the shipping instructions are on the confirmation email).
What is the fault code for a Ford Focus?
Fault code: “C1288 Pressure Transducer Main/Primary Circuit Failure” This ABS Pump Module is a very common failure for the Ford Focus & C-Max vehicles built between 2004 – 2011. The fault causes the ESP light to illuminate permanently on the instrument cluster.
What is diagnostic code for Ford ABS light?
The diagnostic trouble code is for intermittent signal input detected by the BCM (Brake Control Module). If I had caught this problem a little earlier a simple re-routing of the harness would have provided more slack and prevented damage to the parts.
Fault code: “C1288 Pressure Transducer Main/Primary Circuit Failure” This ABS Pump Module is a very common failure for the Ford Focus & C-Max vehicles built between 2004 – 2011. The fault causes the ESP light to illuminate permanently on the instrument cluster.
The diagnostic trouble code is for intermittent signal input detected by the BCM (Brake Control Module). If I had caught this problem a little earlier a simple re-routing of the harness would have provided more slack and prevented damage to the parts.
