Why does my Mondeo on 52 plate not start?
Why does my Mondeo on 52 plate not start?
I’ve got a mk3 mondeo on 52 plate and it won’t start. When I turn the key it turns over but won’t fire up, the dash lights up when the key is put in and the LED flashes but when I turn it all the displays go off and the led doesn’t flash, My hubby suspects it’s immobilised itself and was wondering if there is anyway to over ride the immobiliser?
How to check if your Mondeo is immobilised?
(Engine is immobilised but key will not cancel immobilisation) Check: Leave ignition switched on for at least one minute or until LED starts to flash two-digit code. Note the code being flashed and compare with the following list:- 1 : 3 Key code not received is the key obscured, try again with different key, key may be damaged/faulty
What kind of engine does a Mondeo have?
I’ve got a 52 plate mondeo with a duratec 2.0 petrol engine that has just started idling erratically and stalling. Started suddenly the other day. Instead of idlling normally at about 900 rpm the revs oscillate.
What was the problem with my Ford Mondeo?
The problem started immediately after I’d accelerated the car hard from rest and rev’ed it to about 4500 or 5000 in first and second ….next time I came to idle the problem was there. it ws also a wet day but I didn’t go through any big puddles.
What does it mean when a Ford Mondeo won’t start?
The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Mondeo won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
I’ve got a 52 plate mondeo with a duratec 2.0 petrol engine that has just started idling erratically and stalling. Started suddenly the other day. Instead of idlling normally at about 900 rpm the revs oscillate.
What’s the problem with the Ford Mondeo power steering?
Solution: When converting a petrol engine into a LPG fuel system, an approved Ford cyclinder head should be used that has special nitration hardened valves and valve seats. This will prevent premature wear and lack of power, poor idling etc. Problem: Knocking noise from the power steering system.
What’s the problem with the Ford Mondeo heater?
Revised pads and extra grease have been used since 05/2002 for the Mondeo. Problem: Only cold air from heater even on hot setting. Solution: This year Mondeo is known to suffer from a sticking temperature flap in the heater housing. The solution is to use a torx T50 and free the temperature flap.
