What kind of engine malfunction does a Mondeo have?

Mondeo TDCI 2.0, “engine malfunction”, loss of power. I have a 2010 titanium x tdci 2.0L mondeo, duratorq engine, 163bhp. Engine malfunction light was intermittent a few months back, now it seems to be constant, it runs fine and accelerates, no smoke, no hissing, but the power just isn’t there, like turbo not kicking in.

What should I do if my Mondeo TDCi loses power?

Purchased some normfest dc980 air intake cleaner which should clean erg and turbo. Used obd2 to clear error and no warning light. However still lack of power. Interestingly, after a longish drive the dash messages say engine makfunction, but still no engine warning light and obd2 device using torque life says no error codes.

What’s the problem with the Ford Mondeo power steering?

Solution: When converting a petrol engine into a LPG fuel system, an approved Ford cyclinder head should be used that has special nitration hardened valves and valve seats. This will prevent premature wear and lack of power, poor idling etc. Problem: Knocking noise from the power steering system.

What to do if your Ford Mondeo is hard to start?

A revised wiring harness / sensor should be installed which increases the sensor signal from 5 volts to 12 volts. The increase in voltage will provide a better signal from the sensor. Problem: When the vehicle is left for a period of time, it is very hard to start.

What kind of plate does a Ford Mondeo have?

I have a 2007 Mondeo Ghia 2.0 TDCi (140) on a 57 plate. Unfortunately I have had a medical issue and have spent sometime in hospital, well on the mend now though. Due to this however the car has been stood unused for sometime but was working perfectly beforehand.

What are the common problems with Ford Mondeo engines?

Solution: A common problem with this year TDCi engine is a bad connection for the fuel pressure sensor. To rectify the problem, a gold electrical connector should be used instead of the tin connector. Problem: Engine does not run properly or fails to start.

Is the diagnostic system on a Ford Mondeo?

The diagnostic system is a Delphi one, the first two codes will delete but return, the last three codes will not delete. I’ve checked the 5amp F36 fuse, which I think is the ABS one and removed and re-seated the relays in the engine bay fuse box.

Why does my Ford Mondeo say immobiliser active?

Due to this however the car has been stood unused for sometime but was working perfectly beforehand. Now though, the ‘Immobiliser Active’ message is displayed and the car will not start/turnover. I have tried a number of things including leaving the battery disconnected over night and also ensuring it has been fully charged.

What to do with a loss of power Mondeo?

Loss of power – dieselnut EGR valves can usually be restored to full function by a thorough clean after removal. So would be considerably cheaper at an indi. No expertise or daignostic equip required to do this. Mondeo TDCi 130bhp – Ford. Loss of power – cosmicjazzer Decided to replace just to be certain. Got the new part for £96.

Why is the wastegate not working on my Mondeo?

They get blamed for many a problem but quite often its down to the wastegate being sooted up and very stiff so the actuator cannot close / open it properly. Try taking it off and see if the wastegate moves freely by hand. Usually these throw up a fault code though. Im having similar issues with a 53 mondeo 130 now.

Where is the cylinder temp sender on a Mondeo?

The cylinder temp sender is behind the waterpump/ power steering pulley, check the cable connectors are not loose, before you replace the sensor, also, is the engine running too hot? (gauge normally sits midway) – maybee the sensor is ok and its a different problem

What happens when you lose power in a Ford Mondeo?

Loss Of Power I have a 04 (2005 reg) 2.0 TDCI 130. Whilst driving happily along the temerature gage will drop and become idle, at this point I lose all turbo/accerleration in the car and I have to turn the ignition off and back on again to gain back power, doing this seems to ‘reset’ the car until it happens again.

What kind of engine does a Mondeo have?

It’s a 2010, 2.0 TDCI Titanium X duratorq engine. Initially mine seemed intermittent, but now seems to be constant and after resetting error, as soon as I accelerate up to to a point where the turbo would kick in, the engine malfunction light pops on again.

What kind of car loses power without warning?

Ford Mondeo: 2005 Mondeo Diesel. Car loses power without warning, 2005 Mondeo Diesel. Car loses power without warning, intermittently. This problem has been occurring for about two weeks. When it happens, the fastest the car will go is about 20 mph, regardless of fo…

Is the Ford Mondeo a good diesel car?

Exactly. A turbo diesel in a classy mid-sized car is surprisingly capable and a good alternative for those who instantly turn to a Toyota LandCruiser for towing.

Why does my Ford Mondeo have diesel fumes?

A turbo diesel in a classy mid-sized car is surprisingly capable and a good alternative for those who instantly turn to a Toyota LandCruiser for towing. It’s unlikely that exhaust fumes are being sucked back that far up the car, so it’s more likely to be fumes blowing back from the engine and probably coming in through the air vents in the dash.

How long does it take to replace EGR in Ford Mondeo?

Order an EGR blanking plate off e-bay and get it fitted when the new valve is fitted – also get the hose checked, splits can be difficult to see as the gunk fills the split. BTW the Ford quote was a joke – Jag charge half this for fitting an EGR to an X type, it takes about 15 minutes. Mondeo TDCi 130bhp – Ford. Loss of power – unthrottled

Where is the sensor on a Mondeo 2.0?

The sensor is on the front edge of the head. A diagnostic plug in may help, but codes not guaranteed. The car is going into limp mode to protect the engine. You need to either buy a code scanner (cheap on Amazon) or get someone to read the code (s). A good bet will be the EGR valve playing up.

Why is my Mondeo business edition losing power?

I have a 2012 Mondeo 2.0 Diesel Business Edition and was getting a loss of power to start with when driving off which was probably “Limp Home Mode” and the display would say Engine Malfunction. It would also be prone to stall easily.

Is the Ford Mondeo 2.0 TDCi DPF problem?

DPF problems and issues on the Ford Mondeo 2.0 TDCI are all too common, wasted journeys on the motorway trying to regenerate the filter are a weekly event for some frustrated customers. Would you like to be able to drive your Mondeo without worrying about the filter clogging?

How to replace temperature sensor on Ford Mondeo 2.0 TDCi?

This is how the temperature sensor on Ford Mondeo MK4 2.0 TDCI is replaced. Time 20 minutes. Tools: flat screw driver. Items to take off; battery cover, air filter box, air intake pipe, and also disconnect one of the coolant pipes. Skill: basic. Problem was that the temperature gauge was not moving. Loading…

What is the error code on a 2008 Mondeo?

2008 Mondeo 2.2 TDCI. Going into limp home mode on motorway 2008 Mondeo 2.2 TDCI. Going into limp home mode on motorway journeys once up to normal temperature. Error codes P0131, P0299 and P2297. … read more 2008 Mondeo 2.0 TDci. On start up there is a steering On start up there is a steering malfunction warning on the display.

What kind of engine malfunction does a Mondeo have?