What was the problem with the Mondeo TDCi?

Both occasions, on starting, the glow-plug light would flash, the engine would turn over but it would not start. On the first occasion it was in the dealers for 7 days. Eventually they changed the ICU (Injection control Unit). On the second occasion (1 month later) the same starting problem occurred.

When was the Duratorq common rail added to the Mondeo?

In 2005, there were two new Duratorq common rail (TDCi) options, a 2.2L with 114 kW (155 PS) and a detuned version of the 2.0L with 65 kW (89 PS). Also, the Seat Belt Warning System was added and is now standard, with an audible/visual warning signal reminding the driver to fasten his/her seat belt.

What are the common problems with Ford Mondeo engines?

Solution: A common problem with this year TDCi engine is a bad connection for the fuel pressure sensor. To rectify the problem, a gold electrical connector should be used instead of the tin connector. Problem: Engine does not run properly or fails to start.

What kind of engine does second generation Mondeo have?

For the second generation Mondeo, the Zetec engine was replaced with 1.8 and 2.0 litre Mazda L engines, branded Duratec by Ford.

Is there a glow plug light on my Mondeo?

Only on cold engine on idle the glow plug light flashes. If I am driving the car is OK. Start and stop of engine stop the problem but if I stop the car after few minutes again on idle the error start. If the engine warm up a little bit the problem never happend. Please if you have any suggestion let me know.

What kind of engine does a Ford Mondeo have?

I have a 54 plate (2004) TDci 130 BHP Mondeo, and last month my Glow Plug Light started flashing (and car went into limp mode with no turbo) when I put my foot down. I changed the Fuel Filter and all was well for about 2 weeks (1000 miles) THEN…..

How many miles does a Ford Mondeo Mk3 have?

Mondeo Mk3 2005 130bhp 2.0 tdci. 108000 miles. With normal driving the car behaves OK. I’ve driven at 85mph in 4th gear @4000rpm without any problems. The car starts fine even on cold mornings. However when I’m doing 40-50 mph and put my foot down the car goes into limp mode. Restarting cures it until the next time.

What is the malfunction light on my Mondeo 2.0?

Twice now when driving along my car (2013 Mondeo 2.0 TDCi 140bhp) the engine malfunction light has come on and the car has lost power and seemed unwilling to rev. On both occasions pulling over, shutting it all off for a minute and then restarting has resulted in the car driving fine after.

What to do if your Ford Mondeo is hard to start?

A revised wiring harness / sensor should be installed which increases the sensor signal from 5 volts to 12 volts. The increase in voltage will provide a better signal from the sensor. Problem: When the vehicle is left for a period of time, it is very hard to start.

What’s the problem with the Ford Mondeo power steering?

Solution: When converting a petrol engine into a LPG fuel system, an approved Ford cyclinder head should be used that has special nitration hardened valves and valve seats. This will prevent premature wear and lack of power, poor idling etc. Problem: Knocking noise from the power steering system.

Is the Ford Mondeo Mk5 TDCi 180 safe?

As such, it works in harmony with all of the built-in engine safety parameters of your Ford Mondeo. Choose the safest system you can, from a respected and trusted company, and start enjoying significantly improved performance and economy! Nigel from Telford with a Ford Mondeo MK5 2.0 TDCI 180 said: Wow!

Which is best engine tuning for Mondeo ST TDCi?

Angel Tuning recommend an increase of 35bhp and 45lb ft torque to obtain the best results from a standard ST TDCi Mondeo. With our IN HOUSE developed engine management software we achieve the maximum efficiency from the engine, giving a SMOOTH linear power delivery, for harder, smoother acceleration with no flat spots.

What kind of hose does Mondeo ST TDCi use?

Goodridge kits feature the finest quality stainless steel braided hose, which improves braking performance, eliminates the spongy feel of rubber hoses and provides superior resistance to corrosion. Hose end fittings are zinc plated steel as standard or stainless steel as an option.

What was the problem with my Mondeo injector?

After about 3000 mls the glow plug light started to flash, I took it back to my dealer and was told it was an injector fault. They adjusted the injector and it was OK for a few more 1000 miles. Then the same problem again, same procedure as above and it was OK again. You guessed it happened again, this time they renewed No.3 injector.

What happens when an oxygen sensor goes bad in a Mondeo?

Here are the most common symptoms of a bad oxygen sensor in your Mondeo: More often than not, when an oxygen sensor in your Mondeo goes bad, it will throw a diagnostic trouble code. There are many oxygen sensor related codes.

What’s the mileage on a Ford Mondeo 2?

Ford finally replaced the car for me in November with a brand new identical model. However from the outset this one has had a flat spot/ misfire which occurs only with a warm engine between 1800-2000 rpm, on partial throttle settings. Its also only averaging 40 mpg on reasonably long runs-the other when ok was good for 46.

When does my Mondeo TDCi Powershift go off?

My vehicle is Mondeo 2011 2.0 TDCi 140PS PowerShift. I have had this intermittent problem now for almost 1,5 years. Usually occurs when cold humid weather (spring and autumn when around 0 degrees Celsius).

Why is my Ford Mondeo in limp mode?

Had to stop and restart engine 5-20 times every 20 meters or idle 15min to fault go away. Fault was tracked to PCM and it was changed two months ago. Car ran fine until this morning. Weather again wet and +5 Celsius. Drove 20m and again limp mode, ESP light lit, engine malfunction and transmission limited function.

How can I Fix my Mondeo 2ltr continuous problem?

To confirm the fuel pump is ok, get a local garage to stick a brand new Bosch or Delphi filter in. 12 quid off the bay, you can fit it yourself easily with minimal tools and skill. This will do two things, 1 maybe cure your issue, sown filters are crap and restric the diesel flow, and a new decent filter may fix it.

How to check the specs of a Ford Mondeo 4?

Browse Car Specifications… Browse Car Specifications… Choose a Ford Mondeo 4 version from the list below to get information about engine specs, horsepower, CO2 emissions, fuel consumption, dimensions, tires size, weight and many other facts.

Why is the vibration damper on my Mondeo not working?

The vibration damper has not been fitted in production since 09/2001. Revised pads have been installed since 02/2002. Problem: Engine will not start and fuse F23 blown. Solution: The most likely cause is the fact that the booster heater and fuel injection pump use the same fuse.

The archaic Endura-E 1.8 L turbodiesel engine was dropped and replaced by a more sophisticated 2.0 L Duratorq direct-injection (TDCi) unit with a variable geometry turbine. This clever turbine system allows a certain amount of overboost, giving an extra 10% or so of torque for short periods.

Is the 5 speed tiptronic gearbox on a Ford Mondeo brilliant?

Just for the record if you get another car, I consider the 5 speed tiptronic automatic gearboxes on Ford cars to be brilliant, I have had my Mondeo 2.0 TDCI Est Auto 2004 since new and this gearbox has not given any problems at all. No clutch or flywheel repairs on my car. Its done 142,000 miles on original battery, alternator and serpentine belt.

When did the Ford Mondeo Mk III come out?

Following the standard setting interior of the Volkswagen Passat Mk IV in 1996, Ford paid a great deal of attention to the Mk III’s interior and was the first mainstream manufacturer to react to the new standard set by Volkswagen.

Do you need to Mend Your Ford Mondeo?

Mend – ford, mondeo, warning, lights Need to mend your Ford Mondeo car? Snowflake is warning that temperature is near freezing so take care when driving because there could be ice on road. how do i reset the abs warning light and service light on w reg 2000 1.8 ford mondeo seems to be a changover year and manual no help. with this problem.

Why is the fuel flap on my Mondeo not opening?

The solution is to fit a clip to the clutch spring stop to prevent spring elongation. Problem: Fuel flap does not open. Solution: The probable cause is insufficient spring pressure from a lack of material on the flap. A revised filler flap should be fitted. The revised flap has an extra 1mm of material to ensure spring contact.

What’s the problem with my Ford Mondeo brake pads?

Problem: Repeated premature rear brake pad wear and / or rear brake squeal. Solution: The probable cause is sticking pads in the back plate asembly. The solution is to thoroughly clean the support area for the pads and fit new revised pads. Grease the pad supports with molycote silicone grease.

What’s the problem with the Ford Mondeo heater?

Revised pads and extra grease have been used since 05/2002 for the Mondeo. Problem: Only cold air from heater even on hot setting. Solution: This year Mondeo is known to suffer from a sticking temperature flap in the heater housing. The solution is to use a torx T50 and free the temperature flap.

Can a 2 month old TDCi engine start?

I have a 2 month old TDCi that intermittantly is difficult to start. When the problem occurs the engine cranks but does not fire.There is a beeping sound from under the bonnet and the glow plug dash light flashes. At first when the problem arose the engine would fire on the second attempt but it now takes 3/4 attempts.

What are the problems with the Ford 2.0 TDCi engine?

The engine generates 90 or 115 hp. Typical problems of the first version are the rotor of the water pump, the flywheel and the pulley. Fixing each of these problems is still associated with significant costs today. Many childhood illnesses have caused the manufacturer to decide to upgrade the 2.0 TDCi engine just one year after its introduction.

Where is the TDCi relay located on a Mondeo?

😉 The relay for the TDCI is located in the fuse box (K70) next to the battery, not under the battery tray, it’s also a smaller type of relay and the part number is not the same either.

How much Diesel does a Mondeo 2.0 TDCi engine use?

2.0 TDCi engine – economical and dynamic The 2.0 TDCI (HDI), which goes into heavy Mondeo or the Galaxy family, can easily achieve about 5 liters of diesel per 100 kilometers in urban traffic. In typical city driving, the engine consumes 7-8 liters of diesel per hundred kilometers.

Is the Duratec on a 2003 Ford Mondeo?

However it seems the 1.8 Duratecs are known to smoke a lot, and does seem to be oil control rings as the most common fault. Yeah this is the most likely. However I have significant experience of buying and selling cars, and the mileage and all the documentation looked ‘right’.

Is it safe to buy a 2003 Mondeo?

Front suspension spring snapped (randomly). Smokes. Clutch release bearing broke up. Coolant expansion tank cracked. Coil pack stopped working for cylinder 3. Would you buy another car from this manufacturer? No

What does it mean when a Ford Mondeo won’t start?

The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Mondeo won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.

Where is the TDCi relay located on a car?

Not any More! 😉 The relay for the TDCI is located in the fuse box (K70) next to the battery, not under the battery tray, it’s also a smaller type of relay and the part number is not the same either.

What was the problem with the Mondeo TDCi?