Why does my Jeep Wrangler still crank when I start it?
Why does my Jeep Wrangler still crank when I start it?
You don’t have the same components. The whole problem here is that the computer isn’t powering up like it should when you first turn the key on. The reason the jeep still cranks is that the starter motor circuit is totally separate from the computer.
Is there a code for a Jeep Wrangler YJ 1991?
It doesn’t realize there’s a problem so there’s no code stored. Bottom line is, if you don’t have these symptoms (the clicking noise is the ONLY one that is optional) or are dealing with a pre 91 vehicle, then what follows isn’t going to apply to you.
Why does my Jeep Wrangler have no cel?
The whole reason for that is a) symptom number 1; no CEL means no codes either while the problem is on going, and b) even after you get the jeep started, the computer only sees this as a normal start once it gets power, as if you had just turned the key on right then instead of 10 minutes ago.
Why does my Wrangler engine cut out while driving?
Got the following problem going on with my ’95 Wrangler and wondering/hoping someone here might have an answer. The engine is the four banger. While driving along, it will suddenly cut out and as I coast hoping for a restart before I get ran over from the rear, it will catch and backfire and then run fine for a bit longer.
Why was the ignition system of a Jeep Wrangler so bad?
The ignition system had its flaws due to its mechanical nature—especially because it was dialed in by the human hand. Understand that many things can affect how the engine runs and what it needs in order to run well. The time of the ignition would be something subjected to adjustment in order to run right.
You don’t have the same components. The whole problem here is that the computer isn’t powering up like it should when you first turn the key on. The reason the jeep still cranks is that the starter motor circuit is totally separate from the computer.
What causes a jeep to have a no start condition?
The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc. Does Not Crank Condition: Means that the engine is not cranking when you turn the key to crank the engine.
The whole reason for that is a) symptom number 1; no CEL means no codes either while the problem is on going, and b) even after you get the jeep started, the computer only sees this as a normal start once it gets power, as if you had just turned the key on right then instead of 10 minutes ago.
