How to replace rear wheel bearing on 2014 Subaru Forester?

How to replace rear wheel bearing on 2014 Subaru Forester?

This video was taken using a 2014 Subaru Forester with complete hub rear wheel bearings. The basic instructions probably apply to any late model Subaru with rear wheel bearing hubs. Without any previous experience on this job, it looks us under a half hour per side using professional level shop tools.

Do you need to replace rear wheel bearings?

Rear axles on front-wheel-drive autos are a totally different design and incorporate two bearings in each wheel hub. Due to these hub assemblies’ inherent design, the best repair is a total replacement of the entire hub assembly.

How to replace bike wheel hub bearings-YouTube?

I take apart the hub, clean all the parts, install new ball bearings, repack the races with marine grease, reassemble the hub and adjust the cones. I also show removing and install the freewheel. Loading…

How do you adjust wheel bearings on a VW?

Tighten the inner nut to give the correct amount of play – just enough to let the wheel rotate freely – then bend down the tab. Tighten the other nut hard against it, and bend up the other tab to lock both securely. Give a peened nut a few light taps with a hammer and punch to spread it into the slot. On a VW collar, tighten the cross bolt.

How to change rear wheel bearings on 2001 Suburu Forester?

How do you change rear wheel bearings on a 2001 intrigue Front wheel drive! Pull rear tire and the brakes shoes or disk need to be removed. There will be a plate bolted in the the rear hub which does hold the bearing and seal in place. Remove the plate. Now the bearing is pressed in the hub race.

How to replace a rear wheel bearing in your car?

Wheel bearing replacement. How to replace a rear wheel bearing in your car DIY with Scotty Kilmer. How to replace bad rear wheel bearing on the hub assembly. Rear wheel bearing location, inspection, removal and replacement. DIY car repair with Scotty Kilmer, an auto mechanic for the last 40 years. 1. Bearing Puller: http://amzn.to/2Ba7sjF 2.

How do you replace a rear wheel on a Subaru?

Apply the grease to the puller belt. Insert the snap ring and the axle. Install every thing take off the vehicle in the reverse order you removed it. Reattach the wheel, tighten the lug nuts, remove the jack stands and lower the Subaru vehicle to the ground.

Can a Subaru have a press in wheel bearing?

This feature is not available right now. Please try again later. Come along with Eric O. as he works on a Subaru with a press in rear wheel bearing. This job usually requires a lot of spray, new control arm bushings, a torch, a sawzall, and a lot of bad words. In this video we are gonna use BIG NASTY and do what needs doing!