What are the relays in a Ford Ranger?

Daytime Running Lights (DRL), Back-up Lamps, Transmission, Passenger Air Bag Deactivation Switch, Blower Motor Relay Speed Control Servo/Amplifier Assembly, Generic Electronic Module (GEM), Shift Lock Actuator, Turn Signals Instrument Cluster, 4×4, Main Light Switch, Truck Central Security Module (TCSM)

Where are the fuse panels on a Ford Ranger?

Here you will find fuse box diagrams of Ford Ranger 1998, 1999, 2000, 2001, 2002 and 2003, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Where is the power distribution box on a Ford Ranger?

Power distribution box Ford Ranger 2001-2009. The power distribution box is located in the engine compartment. The power distribution box contains high-current fuses that protect your vehicle’s main electrical systems from overloads.

In this article, you will find fuse box diagrams of Ford Ranger 2012, 2013, 2014 and 2015, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Why does my Ford pickup have a green relay?

You’ll be able to find out if the fuel pump relay, or the fuel pump Inertia Switch, or the fuel pump is the cause of the No Start Condition on your Ford car or pickup. If your fuel injected Ford pickup, van, or car still has the Ford relay, this bad boy will be a green color (like the one in the image viewer).

How does the fuel pump relay work in a Ford?

The fuel injection computer then grounds circuit 1. This activates the fuel pump relay to pass current from circuit 4 to circuit 3. Circuit 3 is the one that runs to the fuel pump (via the Inertia Switch) and delivers the voltage/current it needs to activate.

Where is the relay box on a Ford Ranger?

Well I never found a relay box, but I did find the Battery Saver Relay, which is what I was looking for. It was located on the other side of the partition (or to the right/behind the ABS module). I should say that I believe it to be the BSR, but I could be completely wrong (See picture below).

Where is the ignition switch on a Ford Ranger?

T-Bar Crank and Block lift with extra leaf. White box in second pic is ignition switch. Behind radio on left is GEM/CTM. Behind radio on right is ABS module. Last picture is the bulk head connectors. This is how your wiring is passed through your firewall into the engine bay.

Where are the fuse relays on a Ford Explorer?

The following relays are located on either side of the passenger compartment fuse panel. See your authorized dealer for service of these relays. The following relays are located on either side of the passenger compartment fuse panel. See your authorized dealer for service of these relays.

Are there any dangerous activities at the ranger station?

DISCLAIMER: Activities and vehicle modifications appearing or described at The Ranger Station and it’s pages may be potentially dangerous. We do not endorse any such activity for others or recommend it to any particular person – we simply describe the experiences and opinions of other Ranger/Bronco II owners.

Where are the fuses located on a Ford Ranger?

The fuse panel is located on the left-hand side of the instrument panel facing the driver’s side door. Pull the panel cover outward to access the fuses. The power distribution box is located in the engine compartment near the battery.

Where is the fuse panel on a Ford Ranger?

Passenger compartment fuse panel. The fuse panel is located on the left-hand side of the instrument panel facing the driver’s side door. Pull the panel cover outward to access the fuses. Identifying Passenger compartment fuse panel.

Where are the sensors on a 2009 Ford Ranger?

Repair Topics > Electrical > Sensor Locations > Ford Sensor Locations > 2009 Ford Ranger Sensor… The image shown here is not representative of the sensors you may find in your vehicle.

Where are the fuses located in a Ford Ranger?

Passenger compartment fuse panel. The fuse panel is located on the left-hand side of the instrument panel facing the driver’s side door. Pull the panel cover outward to access the fuses.

Where is the fuse box on a Ford Ranger?

If a fuse blows, all the parts of your vehicle that use that circuit will not work. Once you have determined which fuses to check, follow the procedures under Checking and Replacing Fuses further down this page. The power distribution box is located in the engine compartment on the drivers side near the fender.

The power distribution box is located in the engine compartment near the battery. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

When do you need to replace the ECM power relay?

If there is no power when the key is inserted, the engine will not start, or the battery is dead, you may need to replace the ECM power relay. 1. No power when the key is inserted 2. Engine will not start 3. Battery drain or dead battery Average rating from 130,153 customers who received a Vehicle Engine Electrical Inspection.

Where is the fuse panel on a Ford F-250?

The fuse panel is located below and to the left of the steering wheel by the brake pedal. If equipped with Remote Keyless Entry-Driver Door Unlock Relay Coil, All Door Unlock Relay Coil, All Door Lock Relay Coil, Park Lamp Flash Relay, If not equipped with Remote Keyless Entry-Power Door Lock Motors

Where does the power come from on a Ford EEC relay?

This voltage comes from the ignition switch. Power (in the form of 10 to 12 Volts) is always present in circuit 4 . This voltage comes directly from the battery positive terminal across a fusible link on the starter motor solenoid (on the fender). Ground is always present on circuit 1.

How to tell if a starter relay is bad in a Ford?

Fortunately, all Ford models have a remote relay near the battery, which makes it easy and convenient for troubleshooting. This guide will help you determine whether the starter relay on your Ford has gone bad, using a jumper wire and a multimeter. Disable the ignition system.

What kind of relay do I need for my car?

You will usually see 3, 4, and 5 prong relays. An automotive relay will be working with either a 12vor 5v signal. 12v, the standard of all automotives batteries, and 5v the standard for automotive sensors. For this article, lets just assume we are talking about standard 12v relays.

Where is the fuse box on a 1989 Ford Ranger?

It would seem that the later 1989-1992 Ford Ranger fuse box could use this The alternator is connected to maxi-fuses within the power distribution box which is then connected together with the battery at the starter relay hot terminal. Circuits and components are protected by maxi-fuses.

How big is the fuel tank on a 1991 Ford Ranger?

Engine Specifications There were three different engines available for the 1991 Ford Ranger. The two-wheel drive SuperCab has a 19.60-gallon fuel tank while the rest of the trims hold 16.30 gallons. All trims on the 1991 Ford Ranger have two doors and are 66.80 inches wide.

What causes a 2.3L Ford Ranger to not start?

CASE 1: If the fuel pressure gauge registered 0 PSI. This confirms that the cause of your 2.3L Ford Ranger’s no start problem is caused by a lack of fuel. Now, I usually take one more precaution, before condemning the fuel pump as bad and this is to check that the fuel pump is getting 12 Volts as the engine is cranking.

How to take care of a 91 Ford Ranger?

-Apply the emergency brake. Place shift lever in Park; Neutral for manual transmission. -Turn off all electrical loads such as the radio, lamps, air conditioner, etc. Be sure doors are closed whenever readings are made. -Verify engine coolant is at the specified level. -Verify that battery is at 12 volts or more.

What was the cause of the 1991 Ford Ranger coil 2 failure?

Coil 2 Primary Circuit Failure (1990–91 1.9L MFI/SFI) Loss Of Ignition Diagnostic Monitor LH Side (2.3L) Measured Air Flow High At Base Idle (1986–90 1.9L EFI) Spark Output (SPOUT) Signal Default To 10°.

Where is the Battery Saver relay on a Ford Ranger?

Battery Saver Relay, Auxiliary Relay Box, Restraint Central Module (RCM), Generic Electronic Module (GEM), Instrument Cluster Power distribution box Ford Ranger 2001-2009. The power distribution box is located in the engine compartment.

When did the second generation Ford Ranger come out?

In this article, we consider the second-generation Ford Ranger, produced from 1995 to 1997. Here you will find fuse box diagrams of Ford Ranger 1995, 1996 and 1997, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

What does the coolant warning light on a Ford Ranger mean?

The engine coolant temperature warning light illuminating when the Ford Ranger is moving indicates the engine is overheating. As soon as it’s safely possible, pull off the road, stop and switch off the engine. Continual driving is likely to result in engine damage. Allow several minutes for the engine to cool and once cool, check coolant levels.

What should I do if my Ford Ranger Dashboard Light keeps flashing?

Avoid hard acceleration and drive at a moderate speed. If the light keeps flashing, have vehicle checked as soon as possible. The tyre pressure monitoring system on the Ford Ranger alerts the driver that one or more tyres have become significantly deflated when the warning light comes on.

What does the auto start stop light on a Ford Ranger mean?

• Different tyres / tires that alter ride-height may impair operation. The Ford Ranger auto start stop dashboard light illuminates when the engine has automatically stopped. The light flashes when the engine needs to restart. The indicator is shown with a strike through the symbol if the system is not available.

How do you check the fuse on a Ford Ranger?

On the fuse panel cover, find the number of the fuse you want to check. The diagram on the cover tells you where to locate the fuse on the panel. 3. Check the fuse to see if it is blown. Look through the clear side of the fuse to see if the metal wire inside is separated. If it is, the fuse is blown and should be replaced.

What are the four wheel drive warning lights on a Ford Ranger?

• 4L: Four-wheel drive low is engaged. • 4H: Four-wheel drive high is engaged. The airbag warning light on the Ford Ranger should as a system check come on briefly as the ignition is set to on or when the engine has started. It should then go out after a few seconds.

Why does my Ford 4.0L explorer not start?

So, when your Ford 4.0L Explorer (Aerostar, Ranger or Mountaineer) Cranks but Does Not Start, it’s because one of these components is missing from the mix.

How to test ignition system on Ford 4.0L?

Testing the ignition system on your Ford 4.0L equipped vehicle isn’t hard or difficult. I’ve written a tutorial that’ll show you in a step-by-step manner and you can find it here: How To Test The Coil Pack (Ford 3.0L, 3.8L, 4.0L, 4.2L) (at: easyautodiagnostics.com ).

Why does my Ford Ranger not turn on?

No lights on the dashboard when you turn the key is another dead giveaway that the battery is dead. In the instance where you have the engine swinging strongly at first, but slowly gets weaker and weaker with every swing until it just clicks, means any of the following components could be bad.

What should I do if my Ford Ranger wont start?

On the sophisticated 3.2 Diesel engines you will also want to check all electrical components and sensors like: Crank position sensor.

Is the fuel pump relay good on a Ford Ranger?

(This was suggested in another thread.) RELAYS: Rotated EEC power relay, Fuel pump relay, and AC-WOT relay in power distribution box – no change in behavior in any positions. I know at least FP relay is good because FP comes on with key on and off with key off.

Where is the crank sensor on a Ford Ranger?

Pins 21 & 22 at the PCM connector go to the crank sensor. With the multimeter set to AC voltage I verified that the crank sensor produced an ac voltage signal between .4 and 2.0 volts when the engine was being cranked (per other threads).

Why does my Ford Ranger stall at a traffic light?

Owners have reported the vehicle starting without any problem, only to stall later when stopping at a traffic light. Sometimes refusing to restart. Other symptoms reported are: If your vehicle is under warranty, the first thing to do is report it to your Ford dealership immediately before you troubleshoot anything.

What are the relays in a Ford Ranger?