When to use battery light to test alternator?
When to use battery light to test alternator?
The other critical tool to effectively diagnose an alternator is a scan tool. On older vehicles, the battery light would turn on the alternator light when the alternator output or battery voltage dropped below a preset value. The battery light on modern vehicles, however, is controlled by data and trouble codes.
Is it normal for an alternator to not charge?
Still, it’s perfectly normal for others to see the alternator not charge at all intermittently. One test is not enough if you are diagnosing a charging system problem. All too often, the alternator is condemned as the source of the problem if only battery voltage is present with the engine running.
Can a load test alternator be overheated?
Although load-testing an alternator provides a quick way to test for drive belt slippage, keep in mind that an alternator can easily be overheated when testing for maximum output during low-speed operation for an extended period. Most alternators wi
What should the resistance be for an alternator?
If all this checks out then I suspect you have a wiring issue. I would perform either a voltage drop or resistance measurement of each of the wires from the PCM to the alternator. Also, through the fusible link from the battery to the alternator. You should have less then a half ohm of resistance.
Can a battery voltage test be done on an alternator?
One test is not enough if you are diagnosing a charging system problem. All too often, the alternator is condemned as the source of the problem if only battery voltage is present with the engine running. If this is the case, it only means that the alternator is not charging, but does not reveal why.
What does the battery light on the alternator mean?
This is the same connector that lets the on-board computer know if the alternator is charging or not, which is what the battery light actually means. You can use a volt meter to test what the battery is receiving by connecting it to the middle of the posts while the engine is running.
Still, it’s perfectly normal for others to see the alternator not charge at all intermittently. One test is not enough if you are diagnosing a charging system problem. All too often, the alternator is condemned as the source of the problem if only battery voltage is present with the engine running.
If all this checks out then I suspect you have a wiring issue. I would perform either a voltage drop or resistance measurement of each of the wires from the PCM to the alternator. Also, through the fusible link from the battery to the alternator. You should have less then a half ohm of resistance.
