What can you do with an airbag control module?
What can you do with an airbag control module?
What is also noteworthy about the airbag control module is that it stores crash data and hard codes. This information is what courts sometimes retrieve and use to decipher the events leading up to and during a crash.
How to test your airbag module-safety restore?
Below are the steps you should take to test your airbag module and see that all previous crash data and hard codes have been erased. The process is quite simple. To begin, you need to reinstall the airbag module into your vehicle. Make sure all the wiring that was disconnected in the initial disassembly process is reconnected.
What do you need to know about SRS airbag module?
You know that the SRS airbag module is responsible for tying in the entire airbag system including the airbags themselves, the impact sensors, and even the seat belt pre-tensioners. Without the airbag module working properly, none of these parts can function individually the way they are intended to.
How to test a seat mounted airbag Assembly circuit?
If possible, graph the resistance value data while doing things like turning the steering wheel and adjusting the tilt column. Move seats back and forth and up and down if you are testing a seat mounted side airbag assembly circuit. Perform a wiggle test on all suspect harnesses.
What do part numbers need to match for airbag modules?
The part numbers need to match to work in your vehicle. Good tested airbag computer modules. Good tested airbag computer modules. Good tested airbag computer modules. Good tested airbag computer modules. Good tested airbag computer modules. Good tested airbag computer modules. Good tested airbag computer modules.
Why is an airbag control module so important?
An airbag control module is an important part of your vehicle. In addition to storing crash data and sending cut-off signals to your engine following a crash, it also deploys your airbags.
If possible, graph the resistance value data while doing things like turning the steering wheel and adjusting the tilt column. Move seats back and forth and up and down if you are testing a seat mounted side airbag assembly circuit. Perform a wiggle test on all suspect harnesses.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
