What to do if your Duramax wont start?
What to do if your Duramax wont start?
I doubt that you would ruin the fuel filter primer pump by pumping it real good until the primer pumps hard. (you gotta watch what you say here :rof I would try and re-prime the fuel system again by forcing the fuel through the lines, being real sure that you get all of the air out of the lines and fuel system, and try starting again.
What are the codes for my Duramax injection pump?
It actually is throwing a few codes now I’m not sure if some are old and unrelated but here are the codes: P0089 P0101 P0621 P0700 P1093 U1800 U2104 U2106 U2105. It seems potentially to be my injection pump. What do you guys figure? Click to expand… I would clear all the codes first. This way you can focus on what is newly set.
What did I do to my 2004 Duramax?
I have a 2004 duramax that i reciently changed the fuel line that goes from my fuel sending unit to my steel feed line.. I also replaced my fuel filter housing because the truck was loosing prime.. I primed the fuel filter without the bleeder screw in and it filled the filter as it is supposed to…
What are the old codes for Duramax truck stop?
I cleared the codes… when i tired to rescan for new codes none showed up so im not sure if the old codes were an indication or not…
Why does my 2004 Duramax truck not start?
CLICK HERE TO RESET YOUR PASSWORD! 2004 Duramax WONT START! I have a 2004 duramax that i reciently changed the fuel line that goes from my fuel sending unit to my steel feed line.. I also replaced my fuel filter housing because the truck was loosing prime..
I cleared the codes… when i tired to rescan for new codes none showed up so im not sure if the old codes were an indication or not…
What’s the number on the glow plug on Duramax?
The only code showing up is a number three glow plug, but that code has shown up on and off for a while, and shouldn’t make it impossible to start. Clicking this will make more experts see the question and we will remind you when it gets answered.
It actually is throwing a few codes now I’m not sure if some are old and unrelated but here are the codes: P0089 P0101 P0621 P0700 P1093 U1800 U2104 U2106 U2105. It seems potentially to be my injection pump. What do you guys figure? Click to expand… I would clear all the codes first. This way you can focus on what is newly set.
