How do I program my Ford PATS key?
How do I program my Ford PATS key?
Turn the ignition cylinder ON (RUN) for three seconds, then turn it back to OFF. 5. Within ten seconds, remove the first original key and insert the second original key, and then turn to ON (RUN) for three seconds, and then back to OFF.
How to check blank Pats key using forscan?
This article describes how to check a blank key using FORScan. 0. Insert the blank key in the ignition lock. 1. Detect the module that contains PATS. It is easy: go to Service tab and look what module contains PATS programming function. Depending on the vehicle, it may be PCM, PATS, IC, HEC etc.
How do I program a new Pat key?
Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes. 4.After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car.
What does it mean if your Pats key is not recognized?
If the test returns B1600 code (B10D7:87 for new PATS), it means the blank key is not recognized by PATS and can NOT be programmed for this vehicle. 3.3. If the test returns B1602 code (sometimes simulatenously with B1600, B1601) (B10D7:8F for new PATS), it means PATS is unable to stably read the key transponder.
How to relearn Pats ignition key code program?
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes. 4.After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car.
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
Can You program a Ford Pats key with snap on?
But for a lot of the older cars, when they first started with these security systems, you are able to program them with a scan tool. The Snap-on software has the capability to do that for the Ford PATs keys so let’s go through that on the SOLUS Edge.
How to relearn Ford Pats control function module?
Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
