How to remove service side detection system sensor?
How to remove service side detection system sensor?
To get to the two corner mounted sensors you must remove the rear bumper cover first. Then unplug the module and slid it out of the bracket. According to the Service Manual the new module must be synchronized with the BCM. Thanks for the reply. I can rather easily reach the sensors simply by reaching up from below, without removing the bumper.
How does the side object detection system work?
The Side Object Detection sensor modules (Fig. 8) can be swapped from left to right to aid in isolating the cause of a condition. did y’all ever wonder how we can find out info like this online and the dealer remains clueless??
What is the left side object sensor module?
The Side Object Sensor Module – Left is the master that communicates on the vehicle serial data bus. There is a private serial data bus between the left and right sensors. The scan tool is able to communicate only with the left sensor.
Where are the side detection sensors on a Verano?
It is also possible regarding the side detection system that the sensors are blocked because of snow and ice – you mentioned snow. The side object sensor modules are located on each side of the vehicle behind the rear fascia and are not directly visible from outside the vehicle. The sensors use radar to determine the presence of objects nearby.
To get to the two corner mounted sensors you must remove the rear bumper cover first. Then unplug the module and slid it out of the bracket. According to the Service Manual the new module must be synchronized with the BCM. Thanks for the reply. I can rather easily reach the sensors simply by reaching up from below, without removing the bumper.
Is the right side object detection sensor the same as the left?
At this time, there is a Tech 2 software issue preventing communication or programming with the right Side Object Detection sensor module. Programming for both the left and right modules is the same. Until the software issue is resolved, program both modules in the left position and then install one of them in the right position.
How to remove side object sensor from dcs5011?
Depress the retainer tabs (1) and remove the side object sensor modules (2) from the module brackets (3). 6. Using compressed air, clean any debris from the inside and outside of the module brackets (3). Special Coverage Adjustment N172097060 Side Blind Zone Alert Module Water Intrusion Page 4 of 16 5247447 7.
Is the side object detection system on a Chevy Tahoe?
The Side Object Detection sensor modules (Fig. can be swapped from left to right to aid in isolating the cause of a condition. I have had the same problem on and off for the past year. I had a similar response from the dealer. Everything seems to work fine, but the message some times pops up every few minutes.
