What is a spout plug?
What is a spout plug?
The SPOUT (SPark OUTput) connector is the little plug on the wires going into the TFI module on the distributor. This mode has no advance and operates at the basic timing setting of the distributor. It is this mode that lets the car run without the SPOUT connector in.
Why does my Bronco only start with spout connector out?
These concerns may be caused by the shielding drain wire (Circuit 48.) cutting through the insulation of, and shorting to, the Profile Ignition Pickup (PIP) wire (Circuit 395) or the spark output (SPOUT) wire (Circuit 929) near the Powertrain Control Module (PCM) 60-pin connector.
Why does my truck only start with the spout connector out?
Will only start with Spout Connector out. Hello everyone I have a 88 Bronco with a 5.0. I am trying to trouble shoot why my truck only starts when the spout connector is out. I started haveing this issue a few weeks ago it wouldn’t happen every time just every now and then. Now it happens every time I try to start the truck.
Where is the electrical drain wire on a Bronco?
Locate the (bare) electrical drain wire. Wire end is toward the ICM connector, again, about 5″ (127mm) from the “Y” splice. Unravel wire from the top (ICM) end and down to the area where the bare wire makes contact with the three (3) wires mentioned above.
Where does the ICM connector start on a Bronco?
Unravel aluminum foil tape and electrical drain wire (Circuit 48.) from main bundle, exposing the junction or “Y” splice between the ICM tapeout and the PCM tapeout. Be careful with the foil wrap because it will be reused. NOTE: THE FOIL WRAP LENGTH WILL BE ABOUT 5″ (127mm) BEYOND THE “Y” BRANCH. THE END WILL BE TOWARD THE ICM CONNECTOR.
How to fix spout connector on Ford F150?
10 DegreesBefore top dead center*Base timing specification*Set at warm idle speed (electronically controlled – not adjustable)*Disconnect single wire spout connector (yellow/light green) or remove shorting bar on double wire spout connector at ignition module (terminal #5)*All accessories off*Transmission in neutral (parking brake engaged)
Can a 1994 F-150 start without a spout?
It You really want to know? 1994 f-150, 4.9 with automatic. It won’t start with the spout connector installed. Timing is at exactly 10 degrees btdc … read more 1996 ford e150 5.8l with fender mounted ICM (replaced)code 1359 will not clear.
Why does my E150 not start with the spout on?
It won’t start with the spout connector installed. Timing is at exactly 10 degrees btdc … read more 1996 ford e150 5.8l with fender mounted ICM (replaced)code 1359 will not clear. My OBD2 scanner is showing erratic advance and rpm at idle. … read more
Can a Ford 91 4.9 run with the spout out?
91 4.9 won’t run with spout in, runs with spout out. spout is computer controlled timing check the spout circuit for short to ground corroded insulation on harness where it runs along the intake also look for swollen or oil soaked sections of the harness
