What are the wiring problems on a Chevy Silverado?

Disassembled fuse box to find it was melted and found evidence of combustion, wiring harness connector x2 pin n5 was melted and connector x5 pins g1 h1,2,3,4 k 4,5,6 and j 2,3,4 had melted this is all the damage that I found. See all problems of the 2009 Chevrolet Silverado .

How much does a Chevy Silverado wiring harness cost?

The g. M. Dealership located the wiring harness had caught fire and melted part of the carpet on the front drivers side kick plate. $2,400. 00 to replace the harness and carpet. What’s going to prevent this from happening again?.

Why is my Chevy Silverado not 4 wheel drive?

Also, the engine control module was reprogrammed. Shortly after the repair by the dealer, the vehicle manually shifted into 4 wheel drive when in reverse or drive and would not disengage in inclement weather. In addition, the vehicle idled roughly, shuttered, and then stalled.

How much does it cost to replace a fuse on a Chevy Silverado?

Turned vehicle off, called a tow truck and it was taken to our mechanic. The sealed internal fuse box and wiring harness conections had caught fire and burned, damaging the main fuse panel that costs $450 to replace and the main wiring harness connected to the fuse box.

What are the problems with a 2006 Chevy Silverado?

See all problems of the 2006 Chevrolet Silverado . Loss of blower fan due to burnt/melted wiring harness & blower motor resister burning hot enough to cause a fire. Loss fan motor to a/c & heat. On line there are thousands of the same complaint.

What was the problem with my Chevy Silverado battery?

Shortly after the repair by the dealer, the vehicle manually shifted into 4 wheel drive when in reverse or drive and would not disengage in inclement weather. In addition, the vehicle idled roughly, shuttered, and then stalled. The vehicle was towed to the dealer for further inspection and the battery was replaced.

How can I tell if my Chevy Silverado transmission is bad?

Look for blown fuses or damaged wiring. If the wiring and fuses are good, go to Step 2. The transmission in your truck is controlled by the PCM (powertrain control module). It is sophisticated enough to be able to tell you if there is an issue with your transmission.

What does ” check trailer wiring ” warning message mean?

That warning (“check trailer wiring”) would display and then the message “trailer connected” would generally happen immediately (sometimes after a few seconds). This could be random, or it could happen rapid fire a dozen or more times. The truck is a 2015 3500 Duramax. We bought it new earlier this year.

Why is my shift gauge not working on my Chevy Silverado?

Gauges that are not working could mean a faulty ignition switch. This has been an issue on this truck series. A bad ignition means that there may not be full voltage available to activate the shift solenoids. Replacing the switch will cure the problem. Figure 1. Look for blown fuses or damaged wiring.

Is there a wiring diagram for a Chevy?

CHEVROLET Car Manuals PDF & Wiring Diagrams above the page – Volt Owner & Service Manual, Camino, Cruze, Roadtrek, Camaro, Corvette, Aveo; Chevrolet Car Wiring Diagram – Corvette, Bel Air, Cavalier, Impala, Camaro, Astro, Malibu, Venture, Chevelle, PickUp, Suburban, Tahoe, Sonoma . Chevrolet cars coproration was founded in 1910.

How to troubleshoot the electrical system in a Chevy?

When interior lights start flickering or just don’t want to work at all, your first step is to check fuses and relays. If that checks out, look for a loose wire connector. Don’t forget to check the ignition switch too. Examine the ground cable from the engine to the firewall, particularly if you’re experiencing more than one electrical problem.

What kind of electrical system does a Chevy Silverado have?

The 2500HD and 3500HD models are made for towing heavy loads. The Chevy Silverado 1500 is the more passenger friendly version that benefited from a redesign in 2007. Luckily, the electrical systems of all Silverados hit more than they miss.