Where is the oil drain on a Ford Explorer?
Where is the oil drain on a Ford Explorer?
Slide under the front passenger side of the engine bay with the 15mm socket, a ratcheting wrench and a used oil catch container. The silver metal oil drain bolt is located on the rear edge of the silver metal oil pan facing the back of the vehicle.
How do you change the oil in a Ford Explorer?
Raise the rear of the Explorer with a jack and support it with jack stands on the frame. Place a drain pan under the center of the rear axle. Use a ratchet to remove the drain plug from the rear cover. The ratchet head fits into the square hole in the center of the plug. Allow the gear oil to drain into the pan. Install and tighten the plug.
Where is the drain plug on a car?
Place the drain pan underneath the oil pan on the engine and locate the drain plug. Unbolt the plug using the 3/8-inch ratchet and socket, and allow the oil to drain into the pan. Once the oil is emptied from the engine, reinstall the drain plug using the ratchet.
How big of an oil filler do I need for a Ford Explorer?
Lower the vehicle from the jack stands by using the floor jack. Insert an automotive funnel in to the oil filler hole. The total oil capacity of the Duratec 35 3.5L V6 engine for an oil change with filter replacement is 6 U.S. quarts (or 5.7 liters). (The turbocharged “EcoBoost” version of the Duratec 35 has the same 6.0 quarts (5.7L) oil capacity.
How to change the oil and filter on a Ford Explorer?
How to change the motor oil and filter on a 5th generation 2011-2015 Ford Explorer with the Duratec 35 V6 engine.
What kind of oil do you put in a Ford Explorer?
Ford specifies SAE 5W-30 oil for the 3.5L turbo engine.) It is far better to have slightly less oil than necessary in an engine than to overfill it. Running an engine that has been overfilled with oil may damage seals, gasket or other components. Slowly pour in only about 5 to 5 1/2 U.S. quarts of the new SAE 5W-20 oil in to the engine.
What kind of engine does a Ford Explorer have?
Owners of other Ford or Lincoln vehicles equipped with a Cyclone V6 series engine such as the Edge, Taurus, Flex, Fusion, Mustang, F-150, MKX, MKZ, MKS and MKT may also find these DIY instructions to be helpful.
Where do you find the oil drain plug?
Look at the bottom of the engine oil pan. Around the bottom of the pan, you should see a single bolt. That’s your oil drain plug. (Some vehicle models use a similar round plug, which you can pull to drain the oil.)
Place a couple of chocks at the rear wheels and apply the parking brake. Look at the bottom of the engine oil pan. Around the bottom of the pan, you should see a single bolt. That’s your oil drain plug. (Some vehicle models use a similar round plug, which you can pull to drain the oil.)
