What does the camshaft synchronizer do?
What does the camshaft synchronizer do?
What does a Camshaft Synchronizer Assembly do? The Synchronizer is driven off the camshaft, and sends the camshaft rotational position information to the Powertrain Control Module (PCM) to establish injector synchronization and coil firing sequence in DIS systems.
How to remove the camshaft synchronizer on a Ford Ranger?
It will show the location of the camshaft synchronizer, the removal process, and the installation. Note, before removing the camshaft synchronizer, make sure you mark the location of the housing and tab with a magic marker to ensure the replacement camshaft synchronizer goes in exactly the same way. Loading…
Where is the camshaft synchronizer located on a car?
The the Camshaft Syncro Shaft (Camshaft Synchronizer) is on the top back passenger side of the engine. There is a hold down bolt (#3 in diagram below) that holds it in place. The Camshaft Position Sensor is attached to the top of the Camshaft Sycro Shaft.
Where is the sensor housing on a Ford camshaft?
1. Rotate crankshaft to set No. 1 cylinder at top dead center of the compression stroke. 2. Engage camshaft sensor housing vane in slot of tool No. 6469 (511536). 3. Rotate tool on camshaft sensor housing until tool engages housing notch. (Tool should be square and in contact with entire top of housing.) 4.
What happens when the cam Syncro sensor is left unchecked?
If left unchecked, the bushings will continue to wear to the point where the metal flag that is supposed to pass through the cam position sensor contacts the sensor. This puts a sudden halt on the cam syncro shaft. The gear that engages the camshaft itself is attached to the cam syncro shaft with a roll pin.
When do you need to replace the camshaft synchronizer?
Normally, the camshaft synchronizer can last until the engine wears down but from time to time, it may malfunction and need to be replaced. To replace your car’s camshaft synchronizer, follow these steps.
When to replace the Ford Taurus Cam synchronizer?
Complete replacement of both the synchronizer housing and camshaft position sensor is needed when this happens. Setting the timing for these things can be tricky without the Ford specific tool but they can also be set with a scope. In this video I will show you how to troubleshoot these systems as well as how to set the cam synchronizer timing.
Where is the synchronizer on a Ford Ranger?
Insert cam synchronizer into its socket in the back of the engine, at a 90 degree angle to the back of the block, with the c shaped piece pointed open end towards the driver side and on the far left mark. Since the gear is helical, it will rotate as it goes into the engine and hopefully slips right into the oil pump. drive gear.
How to install Cam positioning sensor in 4.0 V6 Ford?
Remove the 10mm bolt in the bracket on top of the sensor securing it to the block. Twist the bracket and lift the sensor out of the block. Install the sensor and secure it in reverse order of removal. When the cam positioning sensor goes bad, it sets a code. Clear the code using a code reader, available at most big box auto parts stores.
