How do you reset the check coolant additive f350?
How do you reset the check coolant additive f350?
To reset the Check Coolant Additive alert in the Ford F-350 first navigate to the settings menu. Select “vehicle” and then “Maintenance”. Choose “Coolant” upon which there will be a prompt telling You to hold OK if the coolant additive has been checked.
What does check coolant additive mean on f350?
The Check Coolant Additive Light comes on every 600 hours to remind you to check the coolant levels. While this does not indicate a problem, it does mean you should bring your Super Duty in to a certified Ford Service Center for a Coolant Check. DO NOT just add more coolant to the system!
What’s the best coolant additive?
Red Line’s Water Wetter proved to be the best all around cooling agent when mixed with a 30/70 antifreeze/water mix. We saw readings as low as 197 F at the cylinder head and the most efficient heat transfer through the radiator at just over eight percent.
What does the oxygen sensor do on a F350?
Your F350’s oxygen sensors measure the amount of oxygen in the exhaust to help insure that the proper air/fuel mixture is realized.
What does reduced engine power do on a Ford F350?
If the ECU isn’t getting the proper voltage response from the throttle body, it can’t be sure of how much it’ll really accelerate your F350 from the gas pedal input. At this point, it turns on the reduced engine power mode in order to keep the vehicle from running away from you.
What is the throttle position sensor on a Ford F350?
The throttle position sensor is one of the most vital sensors in your F350. If it’s not responding, the ECU has no way of telling how much gas gas you’ve given it. The TPS data also helps determine when the transmission will shift.
What do I need to do to connect my phone to Ford SYNC?
Choose yes. The system displays the Phone Menu once the phone is successfully paired and connected. (The menu list options, such as: Dial a number, Redial, Phonebook, Text Messages, Bluetooth devices, Phone Settings.) Enable your phone’s Bluetooth feature and ensure your phone is discoverable or visible .
How to diagnose a Ford communication network problem?
To diagnose this network, you will need a high-impedance DVOM and a scanner. First, hook up the DVOM (positive lead) to Pin #7 into the back of the DLC connector, the ground lead attached to the chassis. Then, with the ignition switch OFF or ON, there should be NO voltage on the network.
What’s the voltage at rest on Ford communication network?
The voltage at “Rest” for Bus + is 0-.2 v. The voltage at “Rest” for Bus – is 5 v. Remember, to get these readings with the DLC and using a DVOM, remember to have the key ‘Off.’ When a message is being sent, the voltages are reversed. You will need a lab scope to see this.
What does fmem mean for Ford communication network?
All control modules will operate in FMEM. And finally, if both wires are open in one of the branches of the network, only the modules that are on the open side of the network will be affected. Another handy thing to remember is that newer Ford vehicles are often equipped with more than one network, the second being the ISO 9141 protocol.
