How do you remove an engine starter?
How do you remove an engine starter?
Turn off the ignition and remove the negative battery cable from the battery. Remove the positive cable (the large cable that runs to the battery) from the starter. Disconnect all the bolts that hold the starter to the block, using a ratchet. Remove any other supporting brackets holding the starter in place.
How do you replace a Mercedes Benz starter?
Place a wood block right under the engine, close to the side of the mount that you will be removing and raise the engine one or two inches. This will allow you to remove the engine mount. Remove the engine mount. Motor mounts look like this. Mercedes-Benz Engine / Motor Mount Remove the old starter now that you have room.
What’s the best way to repair a starter motor?
Make sure the bolts all line up and then the brushes can be pushed in properly so the springs are pushing down on them. The back plate or brush cover can go on next and the long bolts inserted and done up finger tight. Put one screw into the brush holder to make sure everything is lined up and tighten it all up. Make sure the armature turns freely.
When to replace motor mount on Mercedes Benz?
Mercedes-Benz Engine / Motor Mount Remove the old starter now that you have room. Replace with the new starter. We would recommend that you install the motor mount before you start fastening the starter bolts. This way the engine weight is not on the wood block and jack that you put underneath the engine earlier.
How do you remove a tensioner from a Mercedes?
Remove the top Torx bolt using an E12 Torx socket and a 2″ extension. Remove the lower Torx bolt. Some models also have a shock attached to the tensioner. Remove the upper bolt from the shock to disconnect it from the engine block.
Place a wood block right under the engine, close to the side of the mount that you will be removing and raise the engine one or two inches. This will allow you to remove the engine mount. Remove the engine mount. Motor mounts look like this. Mercedes-Benz Engine / Motor Mount Remove the old starter now that you have room.
Mercedes-Benz Engine / Motor Mount Remove the old starter now that you have room. Replace with the new starter. We would recommend that you install the motor mount before you start fastening the starter bolts. This way the engine weight is not on the wood block and jack that you put underneath the engine earlier.
What should I do if my starter motor is not working?
Step 18 – Once the job is complete, turn the ignition key to check the starter operation, if the starter does not work or makes abnormal noises, recheck the job wiring and starter mounting bolts. A starter motor is designed to crank an engine over and allow the internal combustion process to begin.
How big is the starter bolt on a Mercedes medic?
The bolt is typically 13 mm. It is a challenge to get to the bolt but it can be done using several 3/8 extensions and a 3/8 universal joint Disconnect the cable that feeds the +12 Volts to the starter. The bolt should be 10 mm. Remove the two starter bolts shown below.
