How do you fix ignition switch on Bronco?
How do you fix ignition switch on Bronco?
Start the two new switch mounting bolts bay hand. Then use a Phillips or standard screwdriver to tighten the two mounting bolts until the heads shear off says Alan Ahlstrand in “Ford Ranger & Bronco II: Automotive Repair Manual.” Plug the ignition switch electrical connector.
How do you remove ignition switch from car?
Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right. Pull on both the paperclip and the screwdriver to gently slide the switch out of its current position.
Where is the cover on the ignition switch?
On most vehicles, there is a plastic or metal cover on the ignition lock cylinder. Remove the small screw that holds this cover on, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.
How do you remove ignition switch from steering column?
Remove the two switch mounting bolts. Use an electric drill with a 1/8-inch (3mm) drill bit to drill a hole on the center of the brake-off head screws. Then use an Ex-3 Easy-out tool to unscrew the two mounting bolts. Disengage the ignition switch from the actuating pin by hand and remove the switch from the steering column.
Start the two new switch mounting bolts bay hand. Then use a Phillips or standard screwdriver to tighten the two mounting bolts until the heads shear off says Alan Ahlstrand in “Ford Ranger & Bronco II: Automotive Repair Manual.” Plug the ignition switch electrical connector.
How do you remove the ignition switch from a car?
Use an electric drill with a 1/8-inch (3mm) drill bit to drill a hole on the center of the brake-off head screws. Then use an Ex-3 Easy-out tool to unscrew the two mounting bolts. Disengage the ignition switch from the actuating pin by hand and remove the switch from the steering column.
Remove the two switch mounting bolts. Use an electric drill with a 1/8-inch (3mm) drill bit to drill a hole on the center of the brake-off head screws. Then use an Ex-3 Easy-out tool to unscrew the two mounting bolts. Disengage the ignition switch from the actuating pin by hand and remove the switch from the steering column.
Can you remove the ignition switch from a 1985 Ford Ranger?
The ignition switch on your 1985 Ford Ranger comes equipped with special brake-off head screws impossible to remove with a regular screwdriver or similar tool. You can remove the screws at home, however, by using a special tool that’s readily available at most auto parts stores.
