How do you reset a window motor on a Mini Cooper?
How do you reset a window motor on a Mini Cooper?
It does not matter whether you start the car or not. Put the window all the way up (if you are able). Press and hold the window switch in the up position for 10 or more seconds. Do this with the door closed. Open the door to make sure the window drops as it should. Close the door to make sure it goes back up again.
Why does my Mini Cooper window stop opening?
If the window on your Mini Cooper has stopped opening when you open the door then you may need to reset the window motor and window position sensor in order to make it work again. The window sensor and motor detect that the window is in a different position than it actually is.
Where is the regulator on a Mini Cooper?
Now, look at the old regulator assembly. The window motor is sandwiched in between a plastic frame and the gearbox. The upper frame acts as an adapter panel to secure the motor to the gearbox and at the same time, provide a mounting surface for the motor to the door.
How do you remove a power window motor?
Remove the single #20 Torx screw that holds the power window motor to the window track, then remove the motor from the track. Loosen, but don’t remove, the four #20 screws that hold the motor to the cable assembly. Use your prying tool to hold the cable reel down while you remove the screws—this will prevent it from coming apart.
How do you replace power window motor on Mini Cooper?
Use your prying tool to hold the cable reel down while you remove the screws—this will prevent it from coming apart. Install the new power window motor and tighten the four screws, then reinstall the single screw on the window track. Reconnect the harness to the power window motor assembly and guide it back into the door cavity.
If the window on your Mini Cooper has stopped opening when you open the door then you may need to reset the window motor and window position sensor in order to make it work again. The window sensor and motor detect that the window is in a different position than it actually is.
Now, look at the old regulator assembly. The window motor is sandwiched in between a plastic frame and the gearbox. The upper frame acts as an adapter panel to secure the motor to the gearbox and at the same time, provide a mounting surface for the motor to the door.
Remove the single #20 Torx screw that holds the power window motor to the window track, then remove the motor from the track. Loosen, but don’t remove, the four #20 screws that hold the motor to the cable assembly. Use your prying tool to hold the cable reel down while you remove the screws—this will prevent it from coming apart.
