How to test a cat 262C skid steer?
How to test a cat 262C skid steer?
Verify that CID 2475 – FMI 03is active before performing this procedure. The diagnostic will generate a level 2 warning. The machine will be brought to a stop. The park brake will be engaged and will remain engaged until the diagnostic has been cleared and the hystat lever has been returned to the neutral position. Test Step 1.
How to check a skid steer for corrosion?
Clean the harness contacts of the harness connectors and check the wires for damage to the insulation that is caused by excessive heat, corrosion, or chafing. Perform a 45 N (10 lb) pull test on each of the wires that are associated with the sensor circuit. Reconnect all harness connectors.
Where are the active codes on a skid steer?
The first screen should have been the active codes but, you did not state any had the words SERV CODE or the book showing so, I think it moved on to the logged codes screen. The floppy icon indicates you can save the codes to a SD Card via the slot in the console.
How to measure the DC voltage of a skid steer?
At the harness connector for the right joystick, insert 7X-1710 Multimeter Probes along the contact for the power supply 1 (wire 127-OR) and along ground contact 2 (wire 203-BK). Do not disconnect the machine harness from the connector for the joystick. Measure the DC voltage of the sensor power supply.
What is the serial number for a caterpillar 259D?
I am working on a cat 259D serial# FTL07209. the yellow diamond with an! in it is flashing. Caterpillar 259D I am working on a cat 259D serial# FTL07209. the yellow diamond with an! in it is flashing.
What does diagnostic mean on Cat 262C skid steer?
The diagnostic will generate a level 2 warning. The machine will be brought to a stop. The park brake will be engaged and will remain engaged until the diagnostic has been cleared and the hystat lever has been returned to the neutral position. Test Step 1. CHECK THE SENSOR POWER SUPPLY
When to stop a cat 259D Engine Level 1?
Level 1- If the alert indicator is on continuously, stop the machine at the earliest convenience. Check the following before consulting your Cat dealer. Ensure that the machine has been adequately warmed up. Refer to Engine Starting for an explanation of the engine and ambient conditions that may trigger this.
The first screen should have been the active codes but, you did not state any had the words SERV CODE or the book showing so, I think it moved on to the logged codes screen. The floppy icon indicates you can save the codes to a SD Card via the slot in the console.
