How do you remove the fluid coupling from a motor shaft?

Remove Fluid Coupling: Back off locking screws. Engage the dismounting threaded bar “C” (this is different from mounting threaded bar) onto the back of the fluid coupling (Figure 3). Continue with threading of the rod against the motor shaft.

What is Voith coupling?

The hydrodynamic principle of a fluid coupling makes it easy to gently accelerate driven machines. Voith offers constant-fill and fill-controlled fluid couplings with the transmittable power ranges from 300 W up to 6 MW.

How do you fix a fluid coupling?

Checking Of Oil Fill

Place filling plug in vertical position and remove it.
Rotate the coupling slowly until the oil just comes up to the filling hole. This position must match the angle.
If necessary, remove or add some oil.
Replace filling plug or tighten.

What do you mean by fluid coupling?

A fluid coupling is a device which allows a controlled amount of slip between input & output, between the drive and driven machine, with no mechanical contact. Because of this, fluid couplings offer the engineer real advantages, in many different kinds of power transmission.

What is the horsepower of a cat C15 diesel engine?

The Cat ® C15 Industrial Diesel Engine is offered in ratings ranging from 354-433 bkW (475-580 bhp) @ 1800-2100 rpm.

What are the Cat diesel engine fluids recommendations?

Cat Commercial Diesel Engine Fluids Recommendations Special Publication For All 3500 Series, C175 Series and Smaller Commercial Diesel Engines SAFETY.CAT.COM i03991620 Important Safety Information Most accidents that involve product operation, maintenance and repair are caused by failure to observe basic safety rules or precautions.

How do you remove a fluid coupling from a motor?

1. Remove hex head capscrew which retains the collet. 2. Tap the fluid coupling body with a mallet. The fluid coupling should break free from the motor shaft. 3. Remove input shaft and coupling assembly with sheave from motor shaft adapter. Remove sheave from sheave hub. 4. Assemble PARA-FLEX® Coupling to Fluid Coupling Unit and Driven Equipment

When to use cat Deo-ul in diesel engine?

Cat DEO-ULS and Cat DEO are recommended for all pre-Tier 4 engines that use Ultra Low Sulfur Diesel (ULSD) or Low Sulfur Diesel (LSD) fuels. Cat DEO is recommended for engines using fuels of sulfur levels that exceed 0.1 percent (1000 ppm).

The Cat ® C15 Industrial Diesel Engine is offered in ratings ranging from 354-433 bkW (475-580 bhp) @ 1800-2100 rpm.

Is it safe to use caterpillar pillar machine fluids?

Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and on the product are, therefore, not all inclusive. You must not use this product in any manner different from that considered by this manual without first

How do you remove the fluid coupling from a motor shaft?