Why does my air conditioner not work at idle?

Why does my air conditioner not work at idle?

If its not working at idle RPM of around 600–800 but works at engine cruising RPM of 1000 to 1500 or more, then you are probably a little low on refrigerant. But since its a closed system that means you probably have a slow leak, if it used to work fine.

Can a T-BAP wiring harness go bad?

These things rarely go bad–no moving parts. T-BAP Wiring harness – with the correct signal getting to the ECU, this fixed backfiring poor gas mileage, hard cold start and rough idle. TPS sensor – mechanically, the sensor was probably good but I had to replace it because of where the wire was broken.

How did I Fix my 700 sportsman EFI?

In the interest of getting all the symptoms and attempted fixes into one thread I thought I’d share about how I spent the whole summer chasing down and fixing a spitting, sputtering, quitting-while-hot issue on my ’06 700 EFI. I know this is very long but I think it will be helpful to those of you that have the same symptoms.

Why does my car idle at 700 rpm?

There is an air filter which prevents debris from the air from getting into the chamber. But if this air filter is dirty or clogged, then there will be less clean air passing through it. This will cause the engine to idle rough. Your engine should normally get to around 700 RPM after you start the vehicle.

Why does my 80457s 600 CFM not idle?

The carb idles fine while warming up, but when choke is open & engine is hot, still cannot set curb idle. As I slowly increase curb idle to keep engine from stalling, opening throttle after every 1/8 turn, it will go from barely running to about 2000 rpm & stay there for about a minute or so & then idle down on it’s own & start to die.

When to increase curb idle to keep engine from stalling?

As I slowly increase curb idle to keep engine from stalling, opening throttle after every 1/8 turn, it will go from barely running to about 2000 rpm & stay there for about a minute or so & then idle down on it’s own & start to die. If I increase another 1/8 turn or less it will go up to 2000 rpm & stay there.

Can a 600 cfm carb set curb idle?

Still having the same problem. The carb idles fine while warming up, but when choke is open & engine is hot, still cannot set curb idle.