Where are the relays on a cat 226?
Where are the relays on a cat 226?
So far I have found that the B Relay in the engine compartment has power going to the relay (red wire) but the activation wire (green) is not, with the key on. On the left top inside engine compartment there are 4 relays. They control all that stuff third one from the rear is engine fuel circuit or shut off.
How to fix a cat 226 skid steer problem?
Replaced fuel cut off solenoid which fixed the shut off problem. Ran jumper wire from green wire to power relay A to green wire on power relay B and now all the lights come on and all my fuses have power. So now, machine starts and lights on console operate properly. Now…the pilot controls fail to operate when I push the park light switch.
Where is the ECM on a cat 226b skidsteer?
CHECK THE HYDROSTATIC PILOT SOLENOID FOR A SHORT TO GROUND Locate the hydrostatic pilot solenoid. Disconnect the wire harness from the hydrostatic pilot solenoid. Measure the resistance from contact 3 to contact 68 (wire 201-BK and wire 975-WH) of the wire harness for the ECM.
Where is the interlock on a cat 226b skidsteer?
The interlock ECM is located on the left side of the machine beneath the access cover on the floor of the machine. Remove the wire harness from the ECM. Measure the resistance from contact 3 to contact 68 (wire 201-BK and wire 975-WH) of the wire harness connector.
Replaced fuel cut off solenoid which fixed the shut off problem. Ran jumper wire from green wire to power relay A to green wire on power relay B and now all the lights come on and all my fuses have power. So now, machine starts and lights on console operate properly. Now…the pilot controls fail to operate when I push the park light switch.
So far I have found that the B Relay in the engine compartment has power going to the relay (red wire) but the activation wire (green) is not, with the key on. On the left top inside engine compartment there are 4 relays. They control all that stuff third one from the rear is engine fuel circuit or shut off.
How to get a cat 246 skidsteer to start?
CHECK THE INPUT TO THE INTERLOCK ECM Turn the key start switch to the OFF position. Locate the interlock ECM. Remove the harness from the interlock ECM. Jumper contact 64 to contact 62 of the wire harness connector. Turn the key start switch to the START position. The engine should crank. OK – The engine cranks.
